Kramer KIT-400

#
Feature
Function
16
SETUP 4-way DIP-switch
Set the device behavior, see Step 4: Connect inputs and outputs.
17
SERVICE Mini USB Connector
Connect to a PC to perform a firmware upgrade.
18
HDBT OUT RJ-45 Connector
Connect to KIT-400R.
19
LINK LED
Lights blue when a link is established with the receiver.
Follow powering instructions in Step 5: Connect power.
Failure to use PoC and power connector correctly may destroy the devices!
20
PoC (Power over Cable) Switch
Set the PoC switch to ON on both KIT-400T and KIT-400R.
21
12V DC Connector
Connect to the supplied power adapter, unless the power adapter is connected
to KIT-400R.
KIT-400R
#
Feature
Function
22
PROG USB Connector
Connect to a USB stick to perform firmware upgrades.
23
INPUTS
SELECT Button
Press to select the input (HDBT or HDMI).
24
HDBT LED
Lights blue when the HDBT input is selected.
25
HDMI LED
Lights blue when the HDMI input is selected.
26
MENU Button
Press to enter/exit the on-screen display (OSD) menu. Press together with the
– button to reset to 1080p.
27
ENTER Button
In OSD, press to choose the highlighted menu item. Press together with the
FREEZE/+ button to reset to XGA.
28
–
In OSD, press to move back through menus or decrement parameter values.
29
FREEZE/+ Button
In OSD, press to move forward through menus or increment parameter values.
When not in OSD, press to freeze the display.
30
LINK LED
Lights blue when a link is established with the transmitter.
31
ON LED
Lights green when device is powered.
32
INPUTS
HDBT RJ-45 Connector
Connect to KIT-400T.
33
HDMI™ Connector
Connect to an HDMI source.
34
OUTPUT
HDMI Connector
Connect to an HDMI acceptor.
35
AUDIO 5-pin Terminal
Block Connector
Connect to a balanced stereo audio acceptor.
36
REMOTE Contact-Closure 4-pin
Terminal Block Connector
Connect to contact closure switches (by momentary contact between the
desired pin and GND pin). To turn display on or off, see Step 6: Operate KIT-
400.
37
RS-232
CONTROL 3-pin Terminal
Block Connector
Connect to a serial controller or PC.
38
DATA 3-pin Terminal Block
Connector
Connect to a serial data source or acceptor.
39
RELAY 3-pin Terminal Block Connector
Connections to the internal relay: Normally open (NO), normally closed (NC),
and common (C). Connect to devices to be controlled by relay (for example, a
motorized projection screen).
Follow powering instructions in Step 5: Connect power.
Failure to use PoC and power connector correctly may destroy the devices!
40
PoC (Power Over Cable) Switch
Set the PoC switch to ON on both KIT-400T and KIT-400R.
41
12V DC Connector
Connect to the supplied power adapter, unless the power adapter is connected
to KIT-400T.