MV-6 Quick Start Guide
This guide helps you install and use your MV-6 for the first time.
Go to www.kramerav.com/downloads/MV-6 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
MV-6 3G HD-SDI Multiviewer
Remote control transmitter with batteries
Step 2: Get to know your MV-6
Front Panel
Displays the output signal.
Press to select one of the windows displayed on the screen.
Press to select the active input after selecting one of the windows displayed on the screen.
During normal operation, displays the Window/Input list. During menu operation, displays the
menu options.
Press to navigate the menu options.
Press to select a menu or accept a parameter/value.
Press and hold to disable/enable the front panel buttons.
Press to display all six inputs in the window configuration shown on the button.
Press to display four selected inputs in the window configuration shown on the button.
LAYOUT Full Screen Button
Press to display one selected input as a full screen.
Press to display two selected inputs in the window configuration shown on the button.
Press to select the first user-defined output window configuration (see Step 6).
Press to select the second user-defined output window configuration (see Step 6).
Press to freeze the selected output window.
Press either the H (horizontal) or V (vertical) button to change the position of the active
window (see Step 6).
Press either the H (width) or V (height) button to change the size of the active window (see
Step 6).
Press to move back one level through the menu.
To Next Page
Need help?
General
