Kramer VP-439 - Figure 6: Internet Protocol Properties Window

VP-439 - Operating and Controlling the VP-439
15
15
6. Select Use the following IP Address for static IP addressing and fill in the
details as shown in Figure 6.
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to
192.168.1.255 (excluding 192.168.1.39) that is provided by your IT
department.
Figure 6: Internet Protocol Properties Window
7. Click OK.
8. Click Close.
5.4.2 Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the VP-439 to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
5.4.3 Configuring the Ethernet Port
You can set the Ethernet parameters via the embedded Web pages.