Step 6: Operate and control the VP-440X
Operate VP-440X via:
• Input select and MENU front panel buttons (as well as reset and panel lock buttons).
• Remotely, by RS-232 serial commands transmitted by a touch screen system, PC, or other serial
controller.
• Embedded web pages via the Ethernet.
Select an input via:
• Front panel IN buttons.
• OSD menu.
• Contact closure terminal blocks to select an input remotely with the press of a button (HDMI 1
to HDMI 4, and PC).
• Embedded web pages.
Press the MENU button to configure and control the device via OSD menu:
• Set brightness, contrast, color, etc.
• Select resolution and aspect ratio.
• Select the input source, manage audio
input & output volume.
• Manage microphone settings and volume.
• Define OSD display.
• Configure HDCP behavior on input/output.
• Set auto-switching type and lock mode.
• Set Ethernet IP mode, IP address,
TCP/UDP ports, etc.
• Manage auto power down (Auto Sync Off).
• Manage EDID.
• View device information.
• Reset to factory default parameters.
To Previous Page
Loading...
