Kramer VS-411XS Quick Start Guide

VS-411XS and VS-211XS Quick Start
P/N:
2900- 3014 91 QS
Rev:
3
Scan for full manual
VS-211XS and VS-411XS Quick Start Guide
This guide helps you install and use your VS-211XS / VS-411XS for the first time.
Go to www.kramerav.com/downloads/VS-411XS to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VS-211XS / VS-411XS 4K Auto Switcher
4 Rubber feet
1 Quick start guide
1 Power adapter and cord
1 Bracket set
Step 2: Get to know your VS-211XS / VS-411XS
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
#
Feature
Function
1
SETUP 4-way DIP-Switches
Set the operation DIP-switches (see Connect the inputs and outputs on page 2).
2
IN Buttons
Press to select an HDMI input (button lights orange). (2 for VS-211XS, 4 for
VS-411XS).
3
VOL Push
Buttons
-
Press to decrease audio output volume.
+
Press to increase audio output volume.
4
MUTE
Push Button
Press to mute the audio output.
LED
Lights red when audio output is muted.
5
OUT LED
Lights green when an HDMI output is connected.
6
ON LED
Lights green when the device receives power.
7
HDMI IN Connectors
Connect to an HDMI source (2 for VS-211XS, 4 for VS-411XS).
8
HDMI OUT Connector
Connect to an HDMI acceptor.
9
AUDIO OUT 5-pin Terminal Block
Connector
Connect to a balanced stereo audio acceptor.
10
REMOTE Terminal block Connector:
Connect to contact closure switches by momentary contact between the desired
pin and common GND pin.
VS-211XS: IN 1, IN 2/ CST-1, CST-2
Select input 1 or input 2 (IN 1 or IN 2), or alternatively activate custom triggers
(by momentarily connecting IN 1, IN 2, CST-1 and CST-2 to GND) set up in
Maestro. (Configured via the embedded web pages).
VS-411XS: IN 1, IN 2, IN 3, IN 4
Select input 1 to input 4 (IN 1 to IN 2), or alternatively activate custom triggers
set up in Maestro. (Configured via the embedded web pages).
VOL+, VOL -, MUTE
Set the volume up or down (VOL+/-) and mute the audio output (MUTE).
11
ETHERNET RJ-45 Connector
Connect to a PC via a LAN to control the device.
12
RESET Recessed Button
Press briefly to reset the device parameters to their factory default values,
excluding ETH parameters.
Press and hold (5 seconds) to fully reset the device parameters to their default
values, including ETH parameters.
13
5V DC Power Connector
Connect to the power supply and to the mains electricity.
14
RS-232 3-pin Terminal Block Connector
Connect to a PC or a remote controller to control the device.

Kramer VS-411XS Specifications

General

Brand	Kramer
Model	VS-411XS
Category	Switch
Language	English