Kramer VS-44DT - VS-44 DT Quick Start Guide; Package Contents Check; VS-44 DT Front Panel Overview

#
Feature
Function
15
IR 1
IN 3.5mm Mini Jack
Connect to an IR sensor. Receives IR commands and sends them over HDBT OUT 1
OUT 3.5mm Mini Jack
Connect to the first IR emitter. Transmits IR commands that are sent over HDBT OUT 1
16
IR 2
IN 3.5mm Mini Jack
Connect to an IR sensor. Receives IR commands and sends them over HDBT OUT 2
OUT 3.5mm Mini Jack
Connect to the second IR emitter. Transmits IR commands that are sent over HDBT OUT 2
17
IR 3
IN 3.5mm Mini Jack
Connect to an IR sensor. Receives IR commands and sends them over HDBT OUT 3
OUT 3.5mm Mini Jack
Connect to the third IR emitter. Transmits IR commands that are sent over HDBT OUT 3
18
IR 4
IN 3.5mm Mini Jack
Connect to an IR sensor. Receives IR commands and sends them over HDBT OUT 4
OUT 3.5mm Mini Jack
Connect to the fourth IR emitter. Transmits IR commands that are sent over HDBT OUT 4
19
OUT 1
HDBT RJ-45 Connector
Connect to the first HDBT receiver, (for example, the TP-580RXR)
20
HDMI Connector
Connect to the first HDMI acceptor, (for example, an HDMI display)
21
OUT 2
HDBT RJ-45 Connector
Connect to the second HDBT receiver, (for example, the TP-580RXR)
22
HDMI Connector
Connect to the second HDMI acceptor, (for example, an HDMI display)
23
HDBT OUT 3 RJ-45 Connector
Connect to the third HDBT receiver, (for example, the TP-580RXR)
24
HDBT OUT 4 RJ-45 Connector
Connect to the fourth HDBT receiver, (for example, the TP-580RXR)
25
AUDIO OUT 3.5mm Mini Jack
Connect to an audio acceptor, (for example, active speakers)
26
RS-232
DATA 3-pin Terminal
Block (G,Rx,Tx)
Connect to a serial source/target
CONTROL 3-pin
Terminal Block
(G,Rx,Tx)
Connect to a serial controller
27
PROGRAM USB Connector
Connect to a PC to perform firmware upgrades
28
ETHERNET RJ-45 Connector
Connect to a PC via a LAN
29
AC
Mains
Power Socket
Connect the mains power cord
Fuse
AC mains supply protection fuse
Power Switch
Turns the device on and off
30
HDMI IN 1 Connector
Connect to the first HDMI source, (for example, a Blu-ray disk player)
31
HDMI IN 2 Connector
Connect to the second HDMI source, (for example, a Blu-ray disk player)
32
HDMI IN 3 Connector
Connect to the third HDMI source, (for example, a Blu-ray disk player)
33
HDMI IN 4 Connector
Connect to the fourth HDMI source, (for example, a Blu-ray disk player)
34
IR OUT 3.5mm Mini Jack
Connect to an IR emitter for receiving the combined IR signals from all HDBT port IR
transmissions
35
IR IN 3.5mm Mini Jack
Connect to an external IR receiver for controlling VS-44DT via an IR remote controller
Step 3: Install the VS-44DT
To rack mount the machine attach both ear brackets to the machine (by removing the three screws
from each side of the machine and replacing those screws through the ear brackets) or place the
machine on a table.