Kramer VS-44UHDA

#
Feature
Function
12
INPUT HDMI Connector
Connect to HDMI source (from 1 to 4).
13
AUDIO IN on 3.5 Mini Jack Connectors
Connect to unbalanced stereo analog audio sources (from 1 to 4).
14
AUDIO OUTPUT on 5-pin Terminal
Block Connectors
Connect to balanced stereo analog audio acceptor (see pinout below), from 1 to 4.
15
OUTPUT HDMI Connectors
Connect to HDMI acceptors (from 1 to 4).
16
PROG Mini USB Port
Use for firmware upgrade or communication (connecting to a PC or a serial controller).
17
SETUP DIP-Switches
N/A
18
5V/2A USB Port
Use to charge a device.
19
RESET Button
Press and hold while powering the device to reset IP settings to factory default values.
20
ETHERNET RJ-45 Port
Connect to your LAN.
21
OPTIONAL Terminal Block Connectors
N/A
22
RS-232 3-pin Terminal Block
Connectors
Connect to a PC or a serial controller.
23
Mains Power Connector
Connect to the mains power.
24
Mains Power Fuse
Fuse for protecting the device.
25
Mains Power Switch
Switch for turning the device on or off.
Step 3: Install the VS-44UHDA
To rack mount the machine, attach both ear brackets (by removing the three screws from each side of
the machine and replacing those screws through the ear brackets) or place the machine on a table.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VS-44UHDA. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the VS-44UHDA.