Kramer VS-44UHDA - Page 3

RJ-45 pinout:
Connect the audio output:
For the Ethernet connector, see the wiring diagram below:
To a balanced stereo audio
acceptor:
To a unbalanced stereo
audio acceptor:
PIN EIA /TIA 568B
PIN
Wire Color
1
Orange / White
2
Orange
3
Green / White
4
Blue
5
Blue / White
6
Green
7
Brown / White
8
Brown
For optimum range and performance use the recommended
Kramer cables available at
www.kramerav.com/product/VS-44UHDA.
Step 5: Connect the power
Connect the power cord to VS-44UHDA and plug it into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the power cord that is supplied with the unit.
Warning:
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified
personnel only.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com for updated safety information.
Step 6: Operate the VS-44UHDA
Via the front panel buttons:
The 7-segment display shows the status of the VS-44UHDA during normal operation and displays the device information.
Use the front panel buttons as follows:
 To switch an input to an output, press an output button and then an input button to switch to that output.
 Press ALL to route a selected input to all the outputs.
Web pages:
3.2.1 RS-232 and Ethernet:
RS-232/Ethernet
Baud Rate:
115,200
Parity:
None
Data Bits:
8
Command Format:
ASCII Protocol 3000
Stop Bits:
1
Example (Route input 1 to output 1):
#VID1> 1<cr>
Ethernet Parameters
IP Address:
192.168.1.39
Default TCP Port #:
5000
Subnet mask:
255.255.0.0
Default UDP Port #:
50000
Default gateway:
192.168.0.1
Full Factory Reset
OSD:
Front panel buttons: power off the device, press and hold the
LOCK, EDID and STO buttons simultaneously for 3 seconds while
powering the device, and then release.
Protocol 3000:
“#factory” command.
Web Pages:
In the Device Settings page, click Reset.