Kranzle 105 - Blocked Nozzle Solutions

19
The nozzle is blocked !
No water but the gauge shows full pressure.
Rinse the hose
through first.
You should now have
a powerful stream of
water,
remove the lance and
clean the nozzle.
Using the flat spray lance
you only have to clean the
front nozzle.
Straighten a paper clip
and clean the nozzle.
Insert pointed opject
into the hole
and pull the cap back!
Check visually whether the
nozzle is clean.
Now it works as well
as before.
but if you only
get a few drops
of water from
the lance,
- do it yourself !