22
5. Hold the gun in a separate container and press the trigger.
6. Wait for about a minute until the decalcifier comes out of the gun
(recognisable by its whitish colour)
7. Switch off the machine and allow the solution to act for about 15-20 minutes.
8. Switch the machine back on and rinse it through with clear water for about 2
minutes.
9. Now check whether pipeline resistance is back to an acceptable level.
Repeat the decalcifying process if the pressure without the high pressure lance is
still above 25 bars.
Decalcifiers are caustic!
Observe the instructions for usage and accident prevention. Wear
protective clothing to prevent the decalcifying agent from contacting
your skin, eyes and clothing (e.g. gloves, safety mask etc.)
Detergent and dirty fuel must be disposed of responsibly.
Adjusting ignition electrodes:
For a smooth ignition, the setting of the ignition electrode must be controlled regularly
(after 500 operating hours at the latest).
Care and Maintenance
Fuel System:
Your fuel may contain particles of dirt, or impurities or water may get into the tank during
refuelling. To protect the fuel pump the machine is equipped with a fuel filter. Check this
filter regularly for impurities and clean if necessary.
Check the tank for impurities on a regular basis. Clean the tank when necessary. Empty
the fuel tank using the drainage screw at the bottom of the tank. Clean tank and fuel
pipes thoroughly. Screw drainage screw back in.
To Next Page
Loading...
Need help?
General
