Kreg Crown-Pro - Page 11

www.kregtool.com
Step-by-Step
Position your molding on the Crown-Pro
™
and make your cut.
Once the Crown-Pro
™
and the miter saw have
beencorrectlyset,it’stimetomakeyourrstcut.
Before you set the molding in the Crown-Pro
™
youmustrstipit180°.Thiswillmakeitsoyour
molding is upside down (as shown). The bottom of your
molding will actually be face-up in the Crown-Pro
™
.
Place the inverted molding onto the Crown-Pro
™
,
hold it in place with your hand, and make your cut
as desired.
6
Bottom of Molding
(against the wall)
Top of Molding
(against the ceiling)
WARNING:
!
To reduce risk of kickbacks always follow the safety precautions as
outlined on page 2.