Krendl 500 - Page 42

Rev. Date: 3/14/18 Page 39
MODEL #500
SHREDDER
UPPER HOPPER and LOWER BASE UNIT ASSEMBLY
PARTS LIST
Item # Part # Description
20 561 Key, 1/4" x 1 1/4"
22 541 Pin, Hinge (2)
22-1 FSB080 Roll Pin, 5/32" x 5/8" (2)
23 2530-1 Latch, Bent, 5/16-18 x 2" Hex (2)
23-1 FW007 Washer, 5/16" - 18 Hex (2)
23-2 FN011 Nut, 5/16" - 18 Hex (2)
23-3 FN014 Nut, 5/16" - 18 Lock (2)
24 560-5-Assy-R2 Shredder Box Assembly
24-1 560-5-A-R2 Shredder Box w/Removable End
24-2 560-6-B-R2 Agitator, Shredder Box, 6-tine, 14" (short)
24-3 560-1-B-R2 Agitator, Shredder Box, 6-tine, 14" (long)
24-4 426-6 Bearing, 3/4" 2-bolt Casted (4)
24-5 426-7 Seal, Felt, (4)
25 418 Sprocket, 10T x 3/4" (shredder box) (2) (not included w/shredder box assembly)
26 448 Key, 3/16" x 7/8" (2) (not included w/shredder box assembly)
- - 189 #40 Half Link, 1 per Chain (not shown)
- - 199 #40 Connector/Master Link, 1 per Chain (not shown)
- - DCL500-1 Decal Set for 120 Volt machine (not shown)
- - DCL500-2 Decal Set for 240 and 230 Volt machines (not shown)