Safety Guidelines
6/18 810.00113.0
1 Safety Guidelines
1.1 Meaning of the symbols and safety instructions used in this document
This document contains information that must be observed to protect persons against injuries as well as to prevent
material damage.
The safety instructions to protect persons against injuries are highlighted by a signal panel with a warning triangle
and a signal word defined according to ANSI Z535.6-2006: A1.2.
The signal words are classified according to ANSI Z535.6-2006: C4.2.
Depending on the degree of exposure, the panels are displayed as following:
The text of safety instructions is organized in:
1.2 General safety instructions
Please note that the device is intended exclusively for the application range stated in this document or in the data
sheet. Any other or further usage is deemed as usage not in the specified manner.
Use the device
•
in the specified manner
•
in fault-free condition
•
while minding safety and dangers.
The device may be operated only in its specified performance limits (see Technical specifications).
Have malfunctions that may negatively affect the safety rectified immediately.
Only original parts of the manufacturer are approved as spare parts and accessories.
1.2.1 Due diligence of the operator
The operator is responsible for implementing a suitable safety concept and for procuring additional safety
equipment.
Please note that a safety symbol can never replace the text of safety instructions – the text of safety
instructions must therefore always be read completely.
Points marked with this symbol indicate that fatal or serious injuries will occur if the respective safety
precautions are ignored!
Points marked with this symbol indicate that fatal or serious injuries can occur if the respective safety
precautions are ignored!
Points marked with this symbol indicate that less serious injuries can occur if the respective safety
precautions are ignored!
Points marked with this symbol refer to further information and application hints. This symbol does
not indicate safety instructions.
Description of the type and source of danger
• Description of the consequences if safety instructions are ignored.
 Precautions
Selection of suitable components
• Danger to the operational reliability
 Only such components may be selected that are approved for the planned operating
condition.
To Next Page
Loading...
Need help?
General
