Need help?Do you have a question about the KROHNE OPTIFLUX 4100 and is the answer not in the manual?
General| Type | Electromagnetic Flowmeter |
|---|---|
| Measurement Principle | Electromagnetic induction |
| Application | Liquids, including water, wastewater, chemicals, and slurries |
| Process Pressure | Up to 40 bar |
| Output Signals | 4-20 mA, pulse, Modbus |
| Electrode Material | Stainless steel, Hastelloy |
| Lining Material | PTFE, PFA |
| Housing Material | Stainless Steel |
| Power Supply | 24 V DC |
| Ingress Protection | IP67 |
| Certifications | ATEX, IECEx |
| Accuracy | ±0.2% of measured value |
| Process Temperature | -40°C to +180°C (depending on lining material) |
Defines the safety function of the OPTIFLUX x400, including its compliance with IEC 61508 and safety tolerance.
Specifies conditions and instructions for correct installation and use of the device in a safety-related system.
Details the process of configuring the device for safety application, including parameter locking and safety states.
Provides step-by-step instructions for switching the device from non-SIL to safe operation mode.
Lists fixed and changeable parameters that must be configured for safe operation.
Explains the process of verifying safe configuration parameters via local display or HART interface.
Details the current output conditions for measurement and safe states, including failure signals.
To Next Page