Why are there streaks and spots on my kromo KP202E glasses and dishes?
Streaks and spots on glasses and dishes from your Kromo dishwasher can be caused by too much rinse-aid chemical. To fix this, reduce the rinse aid amount by turning the micrometric dispenser screw. Another cause is water that is too hard. Check the water quality; it must not exceed 5-8°f in hardness.
What to do if my kromo KP202E Dishwasher does not load water?
If your Kromo dishwasher isn't loading water, first check if the water valve is shut and open the hot and/or cold water valve. Another possible cause is a blocked solenoid-valve filter, which you should clean. Also, ensure the overflow pipe is correctly placed. Finally, a defective pressure-switch could be the issue, requiring replacement.
What to do if my kromo KP202E Dishwasher objects are not properly dried?
If the items in your Kromo dishwasher are not drying properly, there could be several reasons. You may not be using enough rinse aid; increase the dosage by turning the dispenser screw. The rack might not be suitable for the items; use a rack that gives the objects an inclined position for better water runoff. Also, avoid letting washed items sit in the wash chamber too long; remove the rack as soon as the cycle stops for quicker air drying. Ensure the rinse temperature is above 80°C by checking the boiler thermostat temperature. Lastly, the surface of the objects may be too rough or porous; consider replacing them or soaking them before washing if the dirt is dry and old.
What to do if my kromo KP202E Dishwasher suddenly stops during operation?
If your Kromo dishwasher suddenly stops during operation, it might be connected to an overload device. Connect the machine to its own overload device, contacting service if needed. Alternatively, a machine safety device might have been triggered, requiring a check of the electrical devices by a service technician.
What to do if my kromo KP202E stops during the wash stage and starts refilling water?
If your Kromo dishwasher stops during the wash stage and starts refilling water, it could be due to the previous day's water not being changed; drain the tank completely and refill it. Another reason might be excessive water temperature in the tank; in this case, call Service to check the thermostat and pressure-switch. It may also be a defective pressure switch.
Why are my Kromo Dishwasher washing results unsatisfactory?
Unsatisfactory washing results from your Kromo dishwasher may be due to several factors. The washing nozzles may be obstructed, or the rack may not rotate; clean the nozzles carefully and check the wash-arm's positioning, tightening it firmly. Foam may be present; use no-foam detergents or reduce the detergent dose and check the rinse-aid dosage. Fats or starches may not be removed due to insufficient detergent concentration. Dirty filters can also be a culprit; remove and clean them with a brush under running water before replacing them. Ensure the tank temperature is between 50°C and 60°C by adjusting the thermostat or checking the heating element. The wash cycle may be too short; select a longer cycle or repeat the current one. Finally, drain dirty wash water, clean the filters, refill ...
Step-by-step guide for powering on and preparing the machine for its first use.
Instructions for selecting wash programs, loading racks, and monitoring cycle progress.
Guidance on safely turning off the machine at the end of the operational day.
Daily cleaning tasks and checks required to keep the machine in perfect running order.
Details on local laws, voltage, power, and safety switch requirements for electrical connection.
Specifications for water pressure, hardness, temperature, and connection types for water supply.
General| Brand | kromo |
|---|---|
| Model | KP202E |
| Category | Dishwasher |
| Language | English |
To Next Page
