kromo KP202E - MAINTENANCE; Routine Maintenance Procedures

EN
page 37
5. MAINTENANCE
5.1 Routine maintenance
WARNING: The machine is not protected against pressurized water jets. Do not use
pressure cleaning system against the machine.
It is recommended to contact the seller of chemicals for proper cleaning instructions,
in order to have detailed indications on methods and products for the correct periodical
machine sanitation.
Do not use bleach or chlorine based detergents.
Daily cleaning is needed to ensure that the machine runs perfectly. The following shall be
carried out:
• Turnthemachinein"STAND-BY" mode, by pressing the push-button "B" of the control
panel (see chap. 2).
• Removethesurfaceltersandcleanthemunderrunningwater(seepict.2).Drainthe
sump water (see chap. 2.2.3).
• Removetheoverow
• Removethepumplterandcleanwithabrushandawatershower.
• Removethearmsbylooseningthexingscrews,andthoroughlycleanthem,andthe
nozzlesunderrunningwater.
• Removetheheatexchangerlter(ifinstalled)andcleanitunderrunningwater(seepict.3).
• Reassemblethepartsandrepositionthewashpipesrmlyinplace.
• Cleanthetankverycarefully,usingawatershower.
• Itisrecommendedtoleavethemachinedooropenattheendoftheday.
• Automaticcycleofmachineself-cleaning/rinsing:recommendedateachdayend.
With the machine on "STAND-BY"mode,removetheoverowpipeand,whenthetank
isempty,presstheSTART“A”key;anautomaticcycleof60secondswillstart,afterthis
the machine will be in "STAND-BY" mode.
• Shutthewatervalve.
ON
STAND BY
ON
STAND BY
pict. 3
pict. 2