Krone EasyCut 28 - Maintenance; Safety and Test Run Procedures

Maintenance
46
Pos: 20.11 /Übersc hriften/Überschri ften 3/A-E/AAbweic hende Anziehdrehmomente @ 369\ mod_1441722353234_ 78.docx @ 2702740 @ 3 @ 1
9.3.4 Deviating Tightening Torques
Pos: 20.12 /BA/W artung/Drehmomente / Anziehdr ehmomenteAbweichend es Drehmoment EasyCu t @ 391\mod_1445869003328 _78.docx @ 2801980 @ @ 1
Screws / nuts MA [Nm]
Nut for shear protection (rotary hub) 300
Bearing housing for cutting disc 50
Bearing housing for blade drum 50
Pos: 20.13 /BA/W artung/Muttern und Schraube n (50h) anziehen @ 0\mod_1196 949864530_78.doc x @ 15293 @ @ 1
Note
Regularly check that nuts and bolts are tightly in place (approx. every 50 hours) and tighten
them if necessary.
Pos: 20.14 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1