Need help?Do you have a question about the Krone EasyCut R 360 and is the answer not in the manual?
General| Brand | Krone |
|---|---|
| Model | EasyCut R 360 |
| Category | Lawn Mower |
| Language | English |
Explains the scope and applicability of the manual.
Defines directional terms used in the instructions.
Explains warning symbols and their meanings.
Specifies the intended application of the disc mower.
Details the approved usage and manufacturer's liability.
Outlines requirements for machine operators and maintenance personnel.
Lists general and specific safety guidelines for operation.
Provides a visual identification of machine components.
Locates and explains the machine's data plate.
Provides contact information for the manufacturer.
Lists key physical measurements of the machine.
Specifies necessary tractor power and PTO speed.
Details required oils, quantities, and types for gearboxes.
Refers to the initial setup document for the device.
Details the procedure for attaching the machine to the tractor.
Covers the installation and adjustment of the PTO shaft.
Outlines safety precautions for road transport.
Describes the process of folding the mower for transport.
Lists pre-operation checks and safety warnings.
Explains the steps for performing mowing operations.
Details how to deploy the safety guard before use.
Provides instructions for safely disconnecting the machine.
Explains how to modify the machine's cutting height.
Describes how to adjust the locking mechanism for the side panel.
Details how to set the ground pressure via compensation springs.
Covers oil level checks and oil changes for the main gearbox.
Details oil checks and changes for the mower drive gearbox.
Instructions for checking and changing oil on the cutter bar.
Explains regular checks for blades and retainers.
Discusses replacement criteria for cutter blades based on wear.
Covers checks and material thickness for retaining bolts.
Details checks for retaining bolts and leaf springs in the QF device.
Outlines inspection procedures for leaf springs.
General safety precautions before lubrication tasks.
Specifies lubrication intervals and grease for PTO shafts.
Provides guidance on cleaning, lubricating, and storing the machine.
Safety precautions before resuming operation after a break.
Instructions for conducting a test run after maintenance.
Explains the function and venting procedure for the friction clutch.
Explains how to use and adjust skids to increase cutting height.
Details the scope of the hydraulic compensation accessory kit.
Covers the installation of hydraulic spring compensation components.
General guidelines for proper disposal after the machine's service life.
Instructions for recycling metal components.
Guidance on the disposal of oils and fluids.
To Next Page