Safety
13
Pos: 22.11 /BA/Sic herheit/Hydraulika nlage @ 2\mod_1203503691986 _78.docx @ 66225 @ 2 @ 1
4.7 Hydraulic system
1 The hydraulic system is pressurised!
2 When connecting hydraulic cylinders and motors, make sure the hydraulic hoses are
connected as specified!
3 When connecting the hydraulic hoses to the tractor hydraulics, make sure that the
hydraulics of both the tractor and the implement have been depressurized!
4 In the case of hydraulic connections between tractor and machine, the coupling sleeves and
plugs should be marked to ensure a proper connection! If the connectors are interchanged,
the function will be reversed (e. g. raising/lowering) - Risk of accident!
5 When searching for leaks, use suitable aids to avoid the risk of injury!
6 Liquids escaping under high pressure (hydraulic oil) can penetrate the skin and cause
serious injury! Seek medical help immediately should injuries occur! Danger of infection!
7 Before working on the hydraulic system, depressurise the system and switch off the engine!
Pos: 22.12 /BA/Sic herheit/Hydraulika nlage Zusatz Alterung der Hydraulikschlauch leitungen @ 3\mod_1204552 944856_78.doc x @ 70772 @ @ 1
8 Check the hydraulic hose lines at regular intervals and replace them if damaged or worn!
The new hoses must fulfill the technical requirements set by the manufacturer of the
implement!
Pos: 22.13 /Übersc hriften/Überschri ften 2/U-Z/Wartung @ 33\mod _1254222340957_78. docx @ 318599 @ 2 @ 1
4.8 Maintenance
Pos: 22.14 /BA/Sic herheit/Wartung/W artung Pos.1 ohne Schwungmass/ Feststellbre mse anziehen (2013-12-18 09: 48:30) @ 17\mod_123623 9576347_78.docx @ 2032 70 @ @ 1
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
Pos: 22.15 /BA/Sic herheit/Wartung/W artung Pos.2 bis 8 ohne Elektr onik @ 73\mod_1308295728 779_78.docx @ 655465 @ @ 1
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When performing maintenance work with the machine raised, always secure it with suitable
supporting elements!
4 Oils, greases and filters must be disposed of correctly!
5 If protective devices and guards are subject to wear, check them regularly and replace them
in good time!
6 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
Pos: 22.16 /BA/Sic herheit/Wartung/W artung Zusatz Schneidwek zeuge @ 12\mod_1224578273 531_78.docx @ 151591 @ @ 1
7 When replacing working tools with cutting edges, use suitable tools and gloves!
Pos: 22.17 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
