Krone EasyCut R 360 User Manual

Index
83
20 Index
A
Abrasion Limit ..................................................... 66
Adjust Locking .................................................... 44
Adjusting Skids ................................................... 76
Adjusting the Compensation Springs ................. 45
Adjusting the cutting height ................................ 43
Adjusting the lateral suspension arm .................. 37
Affixing the Adhesive Safety and Information
Labels ............................................................. 19
After Shearing Off ............................................... 54
Attached devices ................................................ 11
B
Before mowing .................................................... 35
Before the Start of the New Season ................... 74
Blade Changing on Cutting Discs ....................... 67
Blade Quick-Fit Device ................................. 63, 69
Blade screw connection ...................................... 62
Blade Screw Connection .................................... 68
C
Checking the Cutter Blades and Blade
Holder ............................................................. 60
Clutching points .................................................. 25
Commissioning ................................................... 24
Connecting the hydraulic lines ............................ 29
Contact ............................................................... 18
Cutter Blades ...................................................... 61
D
Dangers in Case of Non-compliance with the
Safety Instructions ............................................ 9
Detaching the machine ....................................... 40
Deviating Torque ................................................ 51
Dimensions ......................................................... 22
Direction Information ............................................. 7
Disposal of the machine .................................. 82
Driving and Transport ......................................... 34
F
Filling Quantities and Lubrication Designations for
Gearboxes ...................................................... 23
First installation ................................................... 24
Folding Down Mowing Unit ................................. 38
Folding down the Safety Device ......................... 36
Four supports .......................................... 33, 39, 42
Friction Clutch ..................................................... 75
From Headland Position to Transport Position ... 38
From Transport Position to Headland Position ... 38
H
Headland Position .............................................. 38
Hydraulic connections ........................................ 22
Hydraulic spring compensation
mechanism ............................................... 46, 77
Hydraulic system ................................................ 13
Hydraulics .......................................................... 29
I
Identification Plate .............................................. 18
Identifying Symbols in the Operating
Instructions ....................................................... 7
Inadmissible Modes of Operation ...................... 14
Information Required for Questions and
Orders ............................................................ 18
Install the PTO shaft .......................................... 32
Intended Use ........................................................ 8
Intermediate PTO shaft ...................................... 32
L
Lubricants .......................................................... 23
Lubrication Chart ................................................ 72
M
Mac
hine overview .............................................. 16
Main gearbox ..................................................... 56
Maintenance ................................................ 13, 48
Maintenance – lubrication chart ......................... 71
Maintenance table .............................................. 49
Metric Thread Screws with Control Thread ....... 50
Metric Thread Screws with Countersunk Head
and Hexagonal Socket ................................... 51
Metric Thread Screws with Fine Thread ............ 51
Minimum tractor requirements ........................... 22
Mounting onto the Tractor ............................ 25, 28
Mower Drive Gearbox ........................................ 58
Mowing ............................................................... 35
O
Oil level check and oil change on the cutter
bar .................................................................. 59
Operation ........................................................... 35

Krone EasyCut R 360 Specifications

General

Brand	Krone
Model	EasyCut R 360
Category	Lawn Mower
Language	English