Krone EasyCut R 360 - Page 84

84
P
Periodical Inspection of the Cutting Discs /
Blade Drums ................................................... 65
Periodical Inspection of the Leaf Springs ........... 64
Personnel Qualification and Training .................... 9
Placing in Storage ............................................... 73
Position of the Adhesive Safety Stickers on the
Machine .......................................................... 20
PTO operation .................................................... 12
PTO shaft ................................................ 26, 31, 71
Purpose of Use ..................................................... 8
R
Re-Ordering the Adhesive Safety and
Information Labels .......................................... 19
Replacing the linings ........................................... 70
Rotary hub with shear fuse (optional) ................. 52
S
Safety .................................................................... 8
Safety Instructions and Accident Prevention
Regulations ..................................................... 10
Safety-conscious work practices .......................... 9
Service life of the machine ................................ 8
Setting of the pole protection mechanism .......... 47
Settings .............................................................. 43
Spare Parts ........................................................ 48
Special equipment ............................................. 76
Start-up .............................................................. 28
Switching from working position to transport
position ........................................................... 34
Swivelling parking support into transport
position ..................................................... 33, 39
T
Technical data .................................................... 22
Technical data dimensions ................................ 22
Technical data hydraulic connections ................ 22
Technical data minimum tractor requirements .. 22
Technical Data of the Machine .......................... 22
Test run .............................................................. 74
Test run .............................................................. 48
Tightening torques ............................................. 50
U
Unauthorised Conversion/Modification and
Spare Parts Production .................................. 14
W
Working in the vicinity of power transmission lines
....................................................................... 14