9
English
CONNECTING TO THE POWER SUPPLY
Electricity can be dangerous! Therefore you must always scrupulously abide by the safety
rules.
The appliance must be plugged into a suitable, properly installed electric socket.
The voltage of the appliance has been set in the factory. Check that the mains voltage
matches the voltage indicated on the rating plate on the rear of the appliance.
Make sure the main switch on the rear of the machine is set to “0” before connecting the
Beertender
®
to the mains. Insert the plug into a socket with the correct voltage and turn on
the appliance by moving the main switch to “I” - fig. 10.
The appliance will immediately start cooling the inner chamber as soon as the main switch is
set to “I”.
USING THE BEERTENDER
®
SYSTEM
INSERTING A BEERTENDER
®
KEG
Note: the Beertender
®
may only be used with Beertender
®
Kegs “Compatible Beertender
®
”
containing beer sold by the Heineken group.
The appliance can only be used if it contains a Beertender
®
Keg and only if the main switch
is set to “I”.
The LED on the left side of the control panel, when illuminated, tells you that the appliance
is switched on.
You can open the appliance by pressing the handle on top of the lid. When the handle is
released, you can lift the lid up - fig. 11-12.
Note: do not force the lid beyond the set opening position as this could damage it.
When the lid is completely open, insert a Beertender
®
Keg as shown in the figure - fig. 13.
Remove the upper part of the dispensing head (6) by lifting it upwards as indicated in the
illustration - fig. 14.
Note: this cover can be removed for cleaning.
Install the Beertender
®
keg tap.
Note: Do not try to actuate the tap of the Beertender
®
Keg by hand.
Position the beer tube as shown on drawing - fig. 15.
Return the upper part of the dispensing head in its initial position.
Note: The upper part of the dispensing head cannot be repositioned (fig. 16) if the Beertender
®
keg tap has not been properly set up.
Ensure that the upper part of the dispensing head is positioned in the beer pump mechanism
before closing the lid.
Ensure that the positioning of the upper part of the dispensing head conforms to the one in
the illustration so as not to damage the beer pipe - fig. 16.
Gently close the appliance lid again until it lock - fig. 17.
To Next Page
Loading...