Krups Beertender VB32 - Troubleshooting

14
English
TROUBLESHOOTING
Problem Possible causes Remedies
The appliance does not
come on.
The appliance is not
connected to the mains
power supply.
Connect the appliance
to the power supply.
The upper part of the
dispensing head is not
properly positioned.
The Beertender
®
Keg
tap has been activated
by hand.
Put the Beertender
®
Keg tap back in its
original position.
The Beertender
®
Keg
tap or tube is not
inserted correctly.
Remove the
Beertender
®
Keg tap
from the appliance and
fit it again following
section: Using the
Beertender
®
.
No beer is being
dispensed.
The Beertender
®
Keg
is empty.
Replace the
Beertender
®
Keg with a
new one.
There is no keg inside
the Beertender
®
appliance.
Install a keg inside the
Beertender
®
appliance.
The Beertender
®
appliance tap handle is
not correctly installed/
positioned.
Install/position the
tap cover correctly.
You cannot close
the upper part of the
dispensing head.
The upper part of the
dispensing head was
improperly positioned.
Properly position
the upper part of the
dispensing head.