9
T
he grinding fineness button is
difficult to turn.
O
nly adjust the grinder when it is operating.
S
team does not come out of the
n
ozzle.
A
fter switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly affixed. Make sure the steam
nozzle is not clogged at the aerator (if necessary clean the steam nozzle aerator
w
ith the needle supplied). Empty the tank and remove the Claris filter. Fill the tank
w
ith mineral water high in calcium (> 100 mg/litre or .015oz/gallon), it may take as
many as 5 to 10 cycles of steam at 60 seconds each cycle to achieve a continuous
jet of steam. Once you have a continuous jet of steam you should not have to use
this particular type of water again.
Not enough froth on the milk.
U
sing the needle supplied unblock the small air inlet at the top of the nozzle if
required.
Use a cold container and milk that has been opened recently.
T
ry changing the type of milk if this does not work (UHT or pasteurised).
T
he milk froth is too bubbly.
Check that the 2 ends of the small stainless steel tube in the flexible part of the
s
team nozzle are fitted together properly.
The Auto-Cappuccino accessory
does not suck up the milk
(accessory sold separately)
Check that the tube that goes into the milk is not blocked.
Check that the flexible tube is not twisted and that it is correctly fitted into the
accessory to avoid any air being sucked in.
After having turned the machine off and left it to cool, unblock the outlet of the
Auto-Cappuccino accessory.
The cleaning or descaling program
will not start.
These programs are only possible when the machine requests them ('
clean
' or
'
calc
' light on).
After having filled the water tank,
the light remains on.
Check for correct positioning of the tank in the coffee maker.
Check that the float at the bottom of the tank moves freely.
Rinse the accessory and if necessary remove scale.
After having emptied the coffee
grounds collector, the light
remains on.
Remove the collector, make certain that it is empty, wait for 6 seconds and then
fit it again.
Check that the cleaning tray is correctly pushed in.
A power failure occurred during a
cycle.
The appliance will re-initialise automatically when power is turned on and be ready
for a new cycle.
There is water or coffee under the
appliance.
The drip tray has overflowed: empty it and clean the cleaning drawer.
Check that the drip tray is fitted correctly.
Do not remove the water tank before the end of the cycle.
The 4 red lights flash permanently.
Unplug the machine, remove the Claris cartridge, wait for 20 seconds and then
turn it all back on.
If the fault persists, note the number which appears on the display under the cup
tray and contact the Krups Consumer Service.
EN
To Next Page
Loading...
Need help?
General
