Setting water hardness
The “water tank” light will come on.
P
ress the key
-
Fig. 8
a
s many times as are needed to select the hardness level for the water used
:
0
= very soft, 1
=
soft, 2 = moderately hard, 3 = hard, 4 = very hard.
Setting the coffee temperature
P
ress the steam key to switch to coffee temperature setting : The ‘
c
alc
’
light will come on.
Press the key
- Fig. 8
as many times as are needed to select the desired coffee temperature : 1, 2 or 3.
Setting the automatic electrical power supply cut-off (auto-off)
It is possible to turn your machine off automatically after a number of pre-programmed hours.
Press the steam key to switch to automatic cut-off setting :The ‘
clean
’ light will come on.
Press the key
- Fig. 8
as many times as are needed to select the desired duration: 1 = 1 H, 2 = 2 H, 3 = 3 H, 4 = 4 H.
Preparing the appliance
Pull out and fill the water tank
- Fig. 9
.
Put it back in place by pressing firmly and close the lid again
- Fig. 10
.
Open the coffee bean container lid. Add the coffee beans
- Fig. 11
.
Close the coffee bean container lid again.
NEVER PUT GROUND COFFEE IN THE COFFEE CONTAINER.
It is recommended that you do not use oily, caramelised or flavoured coffee beans for this machine. These kinds of beans
may damage the machine.
Check that the coffee beans do not contain any foreign particles such as grit, as any damage caused by the presence of
foreign particles will negate the warranty.
Do not put water into the coffee bean container.
Remember to fit the drip tray to avoid waste water flowing onto the work surface and staining it or scalding you.
Check that your water tank is clean.
Rinsing of circuits
Turn the appliance on by pressing the button
- Fig. 12
. The light will flash during the pre-heating and initialisation
cycle.
Rinsing out the coffee circuit:
Place a recipient under the coffee nozzles. Press the '
Service
' button
- Fig. 13
quickly to start a coffee circuit rinsing
cycle, which will automatically stop after around 40 mL.
Rinsing out the steam circuit:
Place a container under the steam nozzle and press the ’
Service
’ button for 3 seconds to start a steam circuit rinsing
cycle, which will automatically stop after around 300 mL.
A
ppliances are pre-set in the factory to 2, average temperature.
Appliances are pre-set in the factory to 1 hour.
At each of these stages, you can memorise your settings by pressing the button when you have reached the
setting you want (the 4 lights flash 2 times) or carry on with the procedure. These settings will remain memorised even
if the electrical power is cut off. You can modify these settings at any time by repeating these operations.
Do not fill the water tank with hot water, milk or any other liquid. If you turn on the appliance when the water
tank is not in place or not correctly filled (under the “min.” level,), the “fill water tank” light will come on and making
an espresso or a cup of coffee will be made impossible.
Appliances are pre-set in the factory for hardness level 3.
It is preferable to rinse the 2 circuits out at least once after the machine has not been used for several days.
Each time you plug your machine in, it will carry out an initialisation cycle.
4
To Next Page
Loading...
Need help?
General
