12
ENGLISHFRANÇAISESPAÑOL
DESCALING PROGRAM – TOTAL DURATION: ABOUT 22 MINUTES
The quantity of scale deposited depends on the hardness of the water used. The machine will automatically warn you with a
message when you need to proceed with descaling.
To perform the descaling program, you will need a container with minimum capacity of 21 oz/0.6 l and a Krups F 054 (40 g)
descaling powder.
The descaling program is in three parts – a descaling cycle, then 2 rinsing cycles.
Press button to perform descaling at any time and then choose MAINTENANCE => OK => DESCALING from the
menus displayed.
Caution! To benefit from the warranty conditions, it is essential to perform the machine descaling
cycle when the machine tells you to do so. Be sure to follow the order of operations.
You can continue to use the machine but you are advised to perform the operation as soon as possible.
Press the button to start the automa-
tic descaling program when this message is
displayed.
Clean the cleaning tray, the drip tray and its grid,
and the coffee grounds collector with hot water
and a mild liquid detergent.
Rinse the water tank
with fresh water.
Only use Krups descaling products. You can obtain descaling products from Krups Service Centers.
Do not use conventional amidosulphonic acid or other products containing acid.
The manufacturer may not be held responsible for damage to the machine through use of cleaners or descalers
not specifically recommended.
Be sure to complete the entire descaling cycle to avoid any risk of ingestion of the cleaning solution.
Do not put your hands under the coffee outlets during the cycle.
Make certain to protect your work surface during descaling cycles, especially if they are made
of marble, stone or wood.
These parts cannot
be placed in the
dishwasher.
Follow the instructions shown
on the screen, making sure the
powder dissolves fully.
If the coffee grounds collector is not properly positioned you will be warned by a message.
Reposition the collector again for the cycle to continue automatically.
If a power failure occurs during the cycle, you will have to start it again right from the beginning.
You will not be able to postpone this operation.
GENERAL MAINTENANCE
Always remove the power supply cord from the socket and let your machine cool down before cleaning it.
Do not use utensils or cleaning products likely to scratch or corrode the machine.
Wipe the body of the machine on the outside using a moist cloth.
If your product is equipped with our Claris - Aqua Filter System cartridge F088, please remove this
cartridge before the descaling operation.