DEFRNLITEN
43
ENGLISH
Automatic descaling programme of the steam circuit
A message on the screen will indicate when a descaling programme needs to be run for the
appliance. The frequency of this programme depends on the quality of the water used (the harder
the water, the more often the appliance has to be descaled) and on whether a Claris Aqua Filter
System filter is used or not. To run the descaling programme, you will need a recipient with a capacity
of at least 0.6 litres that may be placed underneath the coffee nozzles and the steam nozzle, and a
KRUPS descaling sachet (F 054 – a 40 g sachet is supplied in the Welcome Pack). The automatic
descaling programme has three phases: one descaling cycle and two rinsing cycles. The programme
lasts approximately 22 minutes.
Caution: To respect the guarantee conditions, the cleaning cycle must be carried out when the
appliance requests you not to postpone it further.
!
Caution: You are not obliged to carry out the descaling programme immediately the appliance
requests it, but it must be carried out reasonably soon. Only use KRUPS descaler sachets
supplied in the Welcome Pack; otherwise the guarantee will not cover any material damage
caused by the use of other brands of sachets. Descaler sachets are available from your
KRUPS After-Sales Service Centre.
!
1
When the machine requests descaling, confirm to start the
programme.
Empty the used coffee collector, take out and empty the drip trays.
2
Remove the water tank.
If you use the Krups Claris Aqua Filter System filter cartridge, remove
it before the descaling operation.
Empty the water tank and then fill it with water up to the CALC mark.
Pour the descaler into the water tank and put it back.
Use a large spoon with a long handle to mix the water in the tank or
remove the water tank and carefully shake it from left to right until
the descaler is fully dissolved.
To Next Page
Loading...
Need help?
General
