Krups KP 5006 - Assembly Information

R E P A I R
9. CheckandcleanoutletofFconnectorinparti cularandinjectorplateholderin
general.
10. Performacompletedescalingresp.rinsingcyclewithoutmountedinjectorplate.
Assemblyinformation
1. Insertthesameinjectorplatewithrearsidef irst.
2. Thenpressinjectorplate againstplateho ldertilllatchatthefrontsideengages.
Itisimportant toflushthemachinethoroughlypriortotheassemblyof
theinjectorplate.Otherwiseremainingimpuritiescanblocktheinjector
again.
Do not exchange
the injector plate.