To Next PageTo Next Page
Need help?Do you have a question about the KStar KSE-4.6k-48 and is the answer not in the manual?
General| Model | KSE-4.6k-48 |
|---|---|
| Rated Power | 4.6kW |
| Max. DC Voltage | 550V |
| Start Voltage | 120 V |
| Rated AC Power | 4.6kW |
| Max. AC Current | 20 A |
| Rated AC Voltage | 230 V |
| Frequency | 50 Hz / 60 Hz |
| Input Voltage | 48 V |
| Output Voltage | 230 V |
| Max. DC Power | 6000 W |
| Max. AC Power | 4600 W |
| AC Voltage Range | 180-280 V |
| Protection Features | Over voltage, Over current, Over temperature, Short circuit |
Instructions for connecting the inverter to the AC power system and load.
Guide on how to connect photovoltaic (PV) panels to the inverter.
Procedures for safely connecting batteries to the inverter.
Details on establishing communication using the RS485 interface.
Instructions for connecting an external Current Transformer (CT) for monitoring.
Describes the mode prioritizing solar energy for loads and battery charging.
Mode that prioritizes charging the battery from solar energy.
Mode for energy storage during low prices and utilization during high prices.
Lists alarm and error codes for troubleshooting inverter issues.
Accesses menus for configuring system parameters.
Configures system settings including working modes, input, and grid connection.
Selects operational modes like self-consumption, peak shift, or battery priority.
Settings for battery type, voltage, depth of discharge, and charge current.
Configuration for reactive power, grid power, and charge/discharge power percentages.
A table matching fault codes to potential causes and solutions.
