What does a DCI Fault mean on my KStar KSG-1K-SM?
A DCI fault indicates that the DC component in the output current is too high. After the alarm occurs, wait for 2 minutes to see if the KStar Inverter recovers automatically.
How to fix a Communication Fault on a KStar KSG-1K-SM Inverter?
If you have a Communication Fault with your KStar Inverter, try restarting the equipment to see if the issue resolves. If the fault continues, further assistance is needed.
What to do if my KStar KSG-1K-SM Inverter says 'No Grid'?
If your KStar Inverter indicates 'No Grid', first, check whether the inverter is properly connected to the municipal grid. Second, verify the cable connection between the inverter and the municipal grid. If the issue persists, further assistance is needed.
Why is my KStar KSG-1K-SM Inverter showing an Over Temperature Fault?
If you're getting an Over Temperature Fault on your KStar Inverter, the inverter's temperature might be too high. Try moving the inverter to a cooler location. If the fault persists, further assistance is needed.
What to do if a KStar KSG-1K-SM has a Current Leakage Fault?
If you're experiencing a Current Leakage Fault with your KStar Inverter: 1. Turn off the inverter and check for leakage in peripheral facilities. 2. After eliminating any peripheral interference, reconnect to the PV array and check for leakage again. If the problem persists, further assistance is needed.
How do I troubleshoot a BUS Over Voltage error on a KStar KSG-1K-SM?
If your KStar Inverter shows a BUS Over Voltage error, try restarting the equipment to see if the issue is resolved. If the fault persists, further assistance is needed.
What should I do if my KStar Inverter shows an EEPROM I/O fault?
Restart the equipment and check whether the EEPROM I/O fault still exists on your KStar Inverter.
What to do if my KStar Inverter is showing an Equipment Fault?
Restart the equipment and check whether the equipment fault still exists on your KStar Inverter.
How to fix a No Grid error on a KStar KSG-1K-SM?
First, verify that your KStar Inverter is properly connected to the municipal grid. Then, check the cable connection between the inverter and the grid.
What to do if KStar Inverter shows a Grid Fault?
First, check if the local municipal grid voltage and frequency comply with the specifications of your KStar Inverter. If an alarm occurs, wait for 2 minutes to see if the inverter recovers automatically.
To Next Page
General
