SET‑UP 4
800035-10
(300 EXC EU, 300 EXC SIX DAYS, 250/300 XC-W, 250/300 XC)
Warning
Risk of injury Battery acid and battery gases cause serious cauteriza-
tion.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and goggles.
– Avoid contact with battery acid and battery gases.
– Keep the battery away from sparks or open fire. Charge only in well
ventilated rooms.
– In the event of skin contact, rinse with large amounts of water. If
battery acid gets in the eyes, rinse with water for at least 15 minutes
and contact a doctor.
– Fill the battery.
Info
Read the notes in the battery package.
– Recharge the battery. ( p. 6)
– Install the battery. ( p. 7)
(EXC SIX DAYS)
– Mount the engine guard.
– Mount the front axle pull.
– Mount the brake lining support bolt.
– Mount the fork bleeding set.
– Mount the handlebar cushion.
Info
Read the accompanying KTM PowerParts installation instructions.
B00097-01
– Mount the frame protector.
Info
Read the accompanying KTM PowerParts installation instructions.
600810-10
(EXC EU, EXC SIX DAYS)
– Mount and tighten the rear mirror adapter and rear mirror on both sides.
– Mount the reflector.
(EXC SIX DAYS, XC, XC‑W)
– Mount the hand guard.
Info
Read the accompanying KTM PowerParts installation instructions.
400730-01
(EXC EU)
– Apply the label.
– Position all controls exactly on the handlebar. Tighten all screws.
– Refuel. ( p. 7)
– Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.