15 ELECTRICAL SYSTEM
112
S00863-10
Main work
– Check the battery voltage.
» Battery voltage: < 9 V
– Do not charge the 12-V battery.
– Replace the 12-V battery and dispose of the old 12-V
battery properly.
» If the specifications have been met:
Battery voltage: ≥ 9 V
– Charge the 12-V battery.
Guideline
The charging current, charging voltage, and charging
time must not be exceeded.
Maximum charging volt-
age
14.4 V
Maximum charging cur-
rent
3.0 A
Maximum charging time 24 h
Recharge the 12-V bat-
tery regularly when the
motorcycle is not being
used
6 months
Battery charger (79629974000)
This battery charger tests whether the 12-V battery
retains its voltage. It is also impossible to overcharge
the 12-V battery with this battery charger. The charging
time may be longer at low temperatures.
This battery charger is only suitable for lithium
iron phosphate batteries. Read the accompanying
KTM Power Parts instructions.
Info
Never remove cover
1
.
– Switch off the battery charger after charging and disconnect it
from the 12-V battery.
Finishing work
– Install the 12-V battery. ( p. 110)
– Install the fuel tank. ( p. 78)
– Mount the seat. ( p. 71)
15.4 Changing the main fuse
Warning
Fire hazard Incorrect fuses overload the electrical system.
– Only use fuses with the required ampere value.
– Do not bypass or repair fuses.
Info
The main fuse protects all electrical power consumers of the vehicle.
To Next Page
Loading...
Need help?
General
