KTM 350 XC-F User Manual (English)

Other manuals for KTM 350 XC-F

Questions and Answers:

D
davischarlesAug 22, 2025
What to do if KTM Motorcycle engine turns but does not start?
- S
  Stephanie VasquezAug 22, 2025
  If your KTM Motorcycle engine turns but doesn't start, it could be due to a disconnected fuel hose, so connect the plug-in connection of the fuel line. The fuel screen in the fuel hose connection might be clogged, requiring a replacement. Incorrect idle speed may be the issue, so adjust it. Also, check if the spark plug is oily or wet – clean and dry it, or replace it if needed. Ensure the spark plug electrode distance (plug gap) is correct; the guideline is 0.8 mm (0.031 in). Inspect the wiring harness for frayed short circuit cables and check the kill switch. Finally, a defect in the fuel injection system could be the cause, requiring a readout of the fault memory using the KTM diagnostics tool.
L
Linda DurhamAug 23, 2025
Why does my KTM 350 XC-F Motorcycle engine not turn on?
- L
  lspencerAug 23, 2025
  Several factors can prevent your KTM Motorcycle engine from turning on. These include: * **Operating error**: Ensure you are following the correct start procedure. * **Discharged battery**: Recharge the battery and check the charging voltage, open-circuit current and the alternator's stator winding. * **Blown main fuse**: Replace the main fuse. * **Defective starter relay**: Inspect the starter relay. * **Defective starter motor**: Examine the starter motor.
K
kanedeborahAug 25, 2025
Why does my KTM Motorcycle engine have too little power?
- B
  Brian JohnsonAug 26, 2025
  If your KTM Motorcycle engine has too little power, several factors could be responsible. A very dirty air filter requires cleaning of the air filter and air filter box. A very dirty fuel filter needs replacement. A defect in the fuel injection system may be present, requiring a readout of the fault memory using the KTM diagnostics tool. The exhaust system might be leaky or deformed, or the main silencer may have too little glass fiber yarn filling, so check for damage and replace the glass fiber yarn filling if needed. Finally, insufficient valve clearance could be the cause, requiring adjustment.
A
Ashley JohnsonAug 27, 2025
Why does my KTM Motorcycle engine overheat?
- C
  Christopher JonesAug 27, 2025
  If your KTM Motorcycle engine overheats, it could be due to several reasons. Check for coolant leaks and ensure the coolant level is correct. Insufficient airflow can also cause overheating, so switch off the engine when standing. Dirty radiator fins should be cleaned. Foam formation in the cooling system requires draining and refilling the coolant. Finally, inspect the radiator hose for bends and replace if necessary.
S
Steven GibsonAug 27, 2025
What to do if KTM 350 XC-F Motorcycle engine turns over but won't start?
- M
  maria72Aug 27, 2025
  If your KTM Motorcycle engine turns but doesn't start, check the following: ensure the fuel hose connection is properly joined. If the fuel screen in the fuel hose connection is clogged, replace it. Adjust the idle speed if it's not set correctly. Clean or replace oily or wet spark plugs, and adjust the plug gap to 0.8 mm (0.031 in) if it's too wide. Check the wiring harness for frayed short circuit cables and the electrical system for defects. Finally, a defect in the fuel injection system may require reading out the fault memory using the KTM diagnostics tool.
O
Olivia PriceAug 29, 2025
Why does my KTM 350 XC-F have no power?
- H
  hawkinsjacobAug 29, 2025
  If your KTM Motorcycle engine has too little power, start by cleaning the air filter and air filter box. If the fuel filter is very dirty, change it. A defect in the fuel injection system may require diagnosis with the KTM tool. Check the exhaust system for leaks or deformation, and replace the glass fiber yarn filling in the main silencer if needed. Lastly, make sure the valve clearance is properly adjusted.
M
Michael SchmidtAug 30, 2025
What does it mean when the FI light is on KTM 350 XC-F?
- C
  Collin HoldenAug 30, 2025
  If the FI warning lamp (MIL) lights up or flashes on your KTM Motorcycle, it indicates a defect in the fuel injection system. You should stop the motorcycle and identify the faulty part using the blink code. Also, check the cabling for damage and the electrical plug-in connections for corrosion and damage. If needed, read out the fault memory using the KTM diagnostics tool.
C
Christina SmithAug 31, 2025
Why is my KTM 350 XC-F using so much oil?
- R
  rebecca11Aug 31, 2025
  If your KTM Motorcycle has high oil consumption, check if the engine vent hose is bent and correct or replace it. Ensure the engine oil level isn't too high. If the engine oil is too thin (low viscosity), change the engine oil and oil filter, and clean the oil screen.
D
Deborah StoneSep 2, 2025
What to do if my KTM 350 XC-F engine does not speed up?
- A
  Andrew FranklinSep 2, 2025
  If your KTM Motorcycle engine does not speed up, there might be a defect in the fuel injection system. In this case, read out the fault memory using the KTM diagnostics tool.
K
Kevin ThomasSep 3, 2025
What to do if my KTM Motorcycle engine dies while riding?
- T
  Traci GriffinSep 3, 2025
  If your KTM Motorcycle engine dies during the trip, the cause might be a lack of fuel, so refuel.

KTM 350 XC-F Specifications

General

Displacement	349.7 cc
Bore/Stroke	88 mm / 57.5 mm
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Front Suspension	WP XACT-USD, Ø 48 mm
Rear Suspension	WP XACT Monoshock with linkage
Ground Clearance	370 mm
Engine Type	Single-cylinder, 4-stroke
Fuel System	Keihin EFI, 44 mm Throttle Body
Frame	Central double-cradle type, 25CrMo4 steel
Front Brake	Disc brake, 260 mm
Rear Brake	Disc brake, 220 mm
Fuel Tank Capacity	8.5 liters