KTM 350 XC-F User Manual (English)

Other manuals for KTM 350 XC-F

Questions and Answers:

Z
zgarnerSep 4, 2025
What to do if my KTM 350 XC-F engine turns but does not start?
- E
  Eric GriffinSep 4, 2025
  If your KTM Motorcycle engine turns but doesn't start, consider these potential causes: * Ensure the fuel hose connection is properly connected. * If the fuel screen in the fuel hose connection is clogged, replace it. * Adjust the idle speed if it's not correctly set. * Clean and dry the spark plug if it's oily or wet, or replace it if necessary. * Adjust the spark plug gap to the recommended 0.8 mm (0.031 in) if it's too wide. * Check the wiring harness for frayed short circuit cables and inspect the kill switch for defects. Also, check the electrical system. * If there's a defect in the fuel injection system, use the KTM diagnostics tool to read the fault memory.
K
Kathleen CastroSep 6, 2025
What to do if the KTM Motorcycle engine does not turn when the starter button is pressed?
- M
  Mr. Patrick Thompson DVMSep 6, 2025
  If your KTM Motorcycle engine doesn't turn when you press the starter, it could be due to several reasons. You might not be following the correct start procedure. The battery could be discharged, requiring a recharge, voltage check, quiescent current check, and stator winding inspection. The main fuse might be blown, necessitating a replacement. Alternatively, the starter relay or the starter motor itself could be defective, requiring a check.
R
Ricardo BeckerSep 7, 2025
What does it mean if the FI warning lamp (MIL) lights up/flashes on my KTM Motorcycle?
- C
  corey83Sep 7, 2025
  If the FI warning lamp (MIL) lights up or flashes on your KTM Motorcycle, it could indicate a defect in the fuel injection system. Stop the motorcycle and identify the faulty part using the blink code. Also, check the cabling for damage and the electrical plug-in connections for corrosion and damage. The fault memory can be read out using the KTM diagnostics tool. Other potential causes include a bent engine vent hose (straighten or replace it), an engine oil level that is too high (check and adjust), or engine oil that is too thin (low viscosity), requiring an engine oil and oil filter change, and cleaning of the oil screen.
B
Benjamin EdwardsSep 8, 2025
Why is my KTM 350 XC-F Motorcycle engine overheating?
- L
  lperezSep 8, 2025
  If your KTM Motorcycle engine overheats, several factors could be the cause. There might be too little coolant in the cooling system, so check the system for leakage and verify the coolant level. Insufficient air stream could be a factor; switch off the engine when standing. Very dirty radiator fins can also cause overheating, so clean them. Foam formation in the cooling system requires draining and refilling the coolant. Lastly, a bent radiator hose should be replaced.
R
Robert RichardsonSep 10, 2025
What to do if the KTM 350 XC-F Motorcycle engine does not turn when the start button is pressed?
- C
  clarkbrianSep 10, 2025
  If your KTM Motorcycle's engine doesn't turn over when you press the start button, here's what might be happening: * **Operating Error**: Make sure you're following the correct start procedure. * **Flat Battery**: The 12-V battery could be discharged. In this case, charge the 12-V battery and check the charging voltage, open-circuit current and the stator winding of the alternator. * **Blown Fuse**: The main fuse might have blown, so replace the main fuse. * **Starter Relay/Motor**: There could be a faulty starter relay or starter motor. Check the starter relay and the starter motor.

KTM 350 XC-F Specifications

General

Displacement	349.7 cc
Bore/Stroke	88 mm / 57.5 mm
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Front Suspension	WP XACT-USD, Ø 48 mm
Rear Suspension	WP XACT Monoshock with linkage
Ground Clearance	370 mm
Engine Type	Single-cylinder, 4-stroke
Fuel System	Keihin EFI, 44 mm Throttle Body
Frame	Central double-cradle type, 25CrMo4 steel
Front Brake	Disc brake, 260 mm
Rear Brake	Disc brake, 220 mm
Fuel Tank Capacity	8.5 liters