What to do if my KTM Motorcycle engine doesn't turn when I press the start button?
If your KTM Motorcycle engine doesn't turn when you press the start button, possible causes include: * Operating error: Ensure you are following the correct start procedure. * A discharged 12-V battery: Charge the battery. * A blown main fuse or fuse 3, 4, or 7: Replace the blown fuses. * No ground connection: Check the ground connection.
Why does my KTM 390 ADVENTURE PH 2022 engine die during the trip?
Your KTM Motorcycle engine might die during a trip due to: * Lack of fuel: Refuel the motorcycle. * A blown main fuse or fuse 3, 4, or 7: Replace the fuses.
What to do if KTM 390 ADVENTURE PH 2022 Motorcycle engine turns but does not start?
If your KTM Motorcycle engine turns but doesn't start, it could be due to: * Operating error: Ensure you are following the correct start procedure. * Malfunction in the electronic fuel injection: Read out the fault memory using the KTM diagnostics tool.
Why does my KTM Motorcycle engine overheat?
Several factors can cause a KTM Motorcycle engine to overheat: * Insufficient coolant: Check for leaks and verify the coolant level. * Dirty radiator fins: Clean the radiator fins. * Foam in the cooling system: Drain and refill/bleed the cooling system. * A defective thermostat: Check the thermostat. * Blown fuse 5: Replace the fuse. * A defect in the radiator fan system: Check the radiator fan system.
How to fix a KTM 390 ADVENTURE PH 2022 Motorcycle engine that has too little power?
If your KTM Motorcycle engine has too little power, consider these potential causes: * A very dirty air filter: Replace the air filter. * A very dirty fuel filter: Check the fuel pressure. * Malfunction in the electronic fuel injection: Read out the fault memory using the KTM diagnostics tool.
What to do if the ABS warning lamp lights up on my KTM 390 ADVENTURE PH 2022 Motorcycle?
If the ABS warning lamp illuminates on your KTM Motorcycle, the following could be the reason: * A blown ABS fuse: Replace the ABS fuses. * A large difference in wheel speeds: Stop the motorcycle, switch off the ignition, and then restart it. * A malfunction in the ABS: Read out the fault memory using the KTM diagnostics tool.
How to reduce high oil consumption in my KTM 390 ADVENTURE PH 2022 Motorcycle?
High oil consumption in your KTM Motorcycle could be due to: * A bent engine vent hose: Route the vent hose without bends or replace it if necessary. * Engine oil level too high: Check the engine oil level. * Engine oil too thin (low viscosity): Change the engine oil and the oil filter, and clean the oil screens.
Why is my KTM 390 ADVENTURE PH 2022 12V battery discharged?
A discharged 12V battery in your KTM Motorcycle can occur if: * The ignition was not switched off when the motorcycle was parked: Charge the 12-V battery. * The 12-V battery is not being charged by the alternator: Check the charging voltage and the open-circuit current.
What does it mean when the malfunction indicator lamp lights up yellow on my KTM Motorcycle?
If the malfunction indicator lamp lights up yellow on your KTM Motorcycle, it indicates a malfunction in the electronic fuel injection. You should read out the fault memory using the KTM diagnostics tool.
Why does my KTM 390 ADVENTURE PH 2022 engine only turn if the clutch lever is drawn?
If your KTM Motorcycle engine only turns when the clutch lever is drawn, it could be because: * The vehicle is in gear: Shift the transmission into neutral. * The vehicle is in gear and the side stand is folded out: Shift the transmission into neutral.
General| Displacement | 373.2 cc |
|---|---|
| Bore x Stroke | 89 mm x 60 mm |
| Compression Ratio | 12.6:1 |
| Torque | 37 Nm @ 7, 000 rpm |
| Transmission | 6-speed |
| Rear Suspension | WP APEX Monoshock |
| Rear Brake | 230 mm disc, single-piston caliper |
| Front Tire | 100/90-19 |
| Rear Tire | 130/80-17 |
| Seat Height | 855 mm |
| Ground Clearance | 200 mm |
| Fuel Capacity | 14.5 liters |
| Weight | 172 kg (dry) |
| Engine Type | Single Cylinder, 4-Stroke, DOHC |
| Power | 32 kW (43 hp) @ 9, 000 rpm |
| Fuel System | Electronic fuel injection |
| Frame | Steel trellis frame |
| Front Suspension | WP APEX 43 mm |
| Front Brake | 320 mm disc, 4-piston caliper |
| ABS | Bosch 9.1 MP |
Provides essential guidelines for safe riding and vehicle operation.
Essential checks and advice before initial operation.
Pre-ride checks to ensure roadworthiness.
Step-by-step guide on how to start the engine.
Explains proper braking techniques and precautions.
Lists essential maintenance tasks based on mileage/time.
Explanation of the ABS system and its modes.
Detailed steps for oil and filter change.
Lists common faults, their possible causes, and actions.
To Next Page
