What to do if my KTM Motorcycle engine doesn't turn when I press the start button?
If your KTM Motorcycle engine doesn't turn when you press the start button, possible causes include: * Operating error: Ensure you are following the correct start procedure. * A discharged 12-V battery: Charge the battery. * A blown main fuse or fuse 3, 4, or 7: Replace the blown fuses. * No ground connection: Check the ground connection.
Why does my KTM 390 ADVENTURE EU 2022 Motorcycle engine die during the trip?
Your KTM Motorcycle engine might die during a trip due to: * Lack of fuel: Refuel the motorcycle. * A blown main fuse or fuse 3, 4, or 7: Replace the fuses.
What to do if KTM Motorcycle engine turns but does not start?
If your KTM Motorcycle engine turns but doesn't start, it could be due to: * Operating error: Ensure you are following the correct start procedure. * Malfunction in the electronic fuel injection: Read out the fault memory using the KTM diagnostics tool.
Why does my KTM 390 ADVENTURE EU 2022 Motorcycle engine overheat?
Several factors can cause a KTM Motorcycle engine to overheat: * Insufficient coolant: Check for leaks and verify the coolant level. * Dirty radiator fins: Clean the radiator fins. * Foam in the cooling system: Drain and refill/bleed the cooling system. * A defective thermostat: Check the thermostat. * Blown fuse 5: Replace the fuse. * A defect in the radiator fan system: Check the radiator fan system.
How to fix a KTM 390 ADVENTURE EU 2022 engine that has too little power?
If your KTM Motorcycle engine has too little power, consider these potential causes: * A very dirty air filter: Replace the air filter. * A very dirty fuel filter: Check the fuel pressure. * Malfunction in the electronic fuel injection: Read out the fault memory using the KTM diagnostics tool.
What to do if the ABS warning lamp lights up on my KTM 390 ADVENTURE EU 2022?
If the ABS warning lamp illuminates on your KTM Motorcycle, the following could be the reason: * A blown ABS fuse: Replace the ABS fuses. * A large difference in wheel speeds: Stop the motorcycle, switch off the ignition, and then restart it. * A malfunction in the ABS: Read out the fault memory using the KTM diagnostics tool.
How to reduce high oil consumption in my KTM 390 ADVENTURE EU 2022 Motorcycle?
High oil consumption in your KTM Motorcycle could be due to: * A bent engine vent hose: Route the vent hose without bends or replace it if necessary. * Engine oil level too high: Check the engine oil level. * Engine oil too thin (low viscosity): Change the engine oil and the oil filter, and clean the oil screens.
Why is my KTM 390 ADVENTURE EU 2022 Motorcycle 12V battery discharged?
A discharged 12V battery in your KTM Motorcycle can occur if: * The ignition was not switched off when the motorcycle was parked: Charge the 12-V battery. * The 12-V battery is not being charged by the alternator: Check the charging voltage and the open-circuit current.
What does it mean when the malfunction indicator lamp lights up yellow on my KTM 390 ADVENTURE EU 2022 Motorcycle?
If the malfunction indicator lamp lights up yellow on your KTM Motorcycle, it indicates a malfunction in the electronic fuel injection. You should read out the fault memory using the KTM diagnostics tool.
Why does my KTM 390 ADVENTURE EU 2022 engine only turn if the clutch lever is drawn?
If your KTM Motorcycle engine only turns when the clutch lever is drawn, it could be because: * The vehicle is in gear: Shift the transmission into neutral. * The vehicle is in gear and the side stand is folded out: Shift the transmission into neutral.
General| Displacement | 373.2 cm³ |
|---|---|
| Bore x Stroke | 89 mm x 60 mm |
| Torque | 37 Nm @ 7, 000 rpm |
| Compression Ratio | 12.6:1 |
| Starter | Electric starter |
| Transmission | 6-speed |
| Final Drive | Chain |
| Fuel System | Electronic fuel injection |
| Frame | Steel trellis frame |
| Rear Suspension | WP Apex monoshock |
| Front Tire | 100/90-19 |
| Rear Tire | 130/80-17 |
| Wheelbase | 1, 430 mm |
| Seat Height | 855 mm |
| Ground Clearance | 200 mm |
| Dry Weight | 172 kg |
| Instruments | TFT display |
| Headlight | LED |
| Engine Type | Single-cylinder, 4-stroke engine |
| Power | 32 kW (43 hp) @ 9, 000 rpm |
| Front Suspension | WP APEX 43 |
| Front Brake | 4-piston radial caliper, 320 mm disc |
| Rear Brake | single-piston caliper |
| Front Wheel | 19 inches |
| Rear Wheel | 17 inches |
| Fuel Capacity | 14.5 liters |
Specifies the intended use and limitations of the vehicle for safe operation.
Describes what constitutes misuse of the vehicle and potential dangers.
General safety advice and the importance of warning labels on the product.
Explains danger, warning, caution, and note symbols and their meanings.
Provides essential guidance for safe operation, including hazards like accidents and burns.
Emphasizes the importance of wearing appropriate protective clothing for injury prevention.
Location and function of the clutch lever on the handlebar.
Location and function of the hand brake lever for the front brake.
Location and function of the throttle grip on the handlebar.
Identifies switches on the left and right sides of the handlebar.
Location and operation of the ignition and steering lock.
Procedures for opening and closing the fuel tank filler cap.
Location and safety system related to the side stand.
Explanation of warning lights and indicator lamps on the dashboard.
Detailed breakdown of the combination instrument display elements and their functions.
How fuel level and coolant temperature are displayed.
Function and settings of the shift warning light for gear changes.
General navigation through the combination instrument menu system.
Configuration options for ABS and MTC (Traction Control) systems.
Steps to adjust the handlebar position for rider comfort and control.
Procedure for adjusting the windshield to different positions.
Adjusting the basic position of the hand and clutch brake levers.
Adjusting the basic position and free travel of the foot brake lever.
Procedure for adjusting the position and range of the shift lever.
Essential checks and maintenance before riding for safety and roadworthiness.
Procedures and safety precautions for starting the motorcycle's engine.
Guidance on how to start moving from a standstill smoothly.
General advice on shifting gears, riding techniques, and safety warnings.
Proper methods for applying front and rear brakes safely.
Procedures for safely stopping and parking the motorcycle.
Safety precautions and steps for refueling the motorcycle.
List of mandatory maintenance tasks and their intervals.
List of recommended maintenance tasks for optimal performance.
Adjusting compression and rebound damping of the front fork.
Adjusting spring preload and rebound damping of the rear shock absorber.
Procedures for lifting the motorcycle with front and rear lifting gear.
Steps for cleaning and checking chain tension.
Procedures for checking brake discs, linings, and fluid levels.
Steps for removing and installing the front and rear wheels.
How to check tire condition, tread depth, age, and pressure.
Procedures for removing, installing, and charging the 12-V battery.
Procedures for changing main, ABS, and individual circuit fuses.
Checking and adjusting the headlight setting and range.
Procedures for checking coolant and antifreeze levels.
Procedures for draining, filling, and bleeding the cooling system.
Procedure for changing the motorcycle's coolant.
Checking and adjusting the play in the clutch lever.
Procedure for checking the engine oil level.
Procedure for changing engine oil, oil filter, and cleaning oil screens.
Procedure for adding engine oil to the correct level.
Lists common faults, possible causes, and recommended actions.
Detailed technical specifications for the engine.
Torque specifications for various engine components.
Technical details for chassis components like frame and brakes.
Technical data and adjustment ranges for fork and shock absorber.
Torque specifications for various chassis components.
Specifications and recommendations for brake fluid types.
Specifications and recommendations for coolant and antifreeze.
Specifications and recommendations for engine oil.
Super unleaded fuel requirements and ethanol content limits.
Symbols indicating an error condition requiring immediate intervention.
Symbols indicating prompt intervention or active driving aids.
To Next Page