What to do if the horn, brake light, turn signal, and radiator fan are not working on my KTM 500 EXC-F 2018 Motorcycle?
If the horn, brake light, turn signal, and radiator fan on your KTM Motorcycle are not working, this is likely due to a blown fuse 3. Replace the fuse.
General| Displacement | 510.4 cc |
|---|---|
| Bore x Stroke | 95 mm x 72 mm |
| Starter | Electric starter |
| Transmission | 6-speed |
| Cooling | Liquid cooled |
| Fuel System | Keihin EFI, throttle body 42 mm |
| Rear Suspension | WP Xplor PDS shock absorber |
| Seat Height | 960 mm |
| Ground Clearance | 355 mm |
| ABS | No |
| Engine Type | Single cylinder, 4-stroke |
| Frame | Central double-cradle type 25CrMo4 steel |
| Front Brake | Single 260 mm disc |
| Rear Brake | Single 220 mm disc |
| Fuel Tank Capacity | 9 l |
| Front Suspension | WP Xplor 48, USD fork |
Explains the meaning of various symbols used in the manual.
Explains the typographical formats used in the document.
Defines the intended use and compliance of the vehicle.
Describes dangers and consequences of using the vehicle improperly.
Provides general safety instructions for operating the vehicle.
Explains risk levels and associated warning symbols.
Warns against tampering with noise control systems and lists prohibited acts.
Provides essential guidelines for safe vehicle operation and rider fitness.
Emphasizes the importance of appropriate protective clothing for rider safety.
Outlines rules and recommendations for performing work on the vehicle.
Provides advice on responsible use and environmental consciousness.
Stresses the importance of reading and keeping the Owner's Manual.
Details warranty coverage and conditions for KTM motorcycles.
Specifies approved substances and environmental hazards.
Recommends using approved parts and accessories for safety.
Highlights the importance of proper service for vehicle operation and longevity.
Notes that figures may depict special equipment and may not show all parts.
Provides information on obtaining customer support and dealer information.
Illustrates the front left view of the vehicle, identifying key components.
Illustrates the rear right view of the vehicle, identifying key components.
Locates the chassis number stamped on the steering head.
Identifies the location of the type label on the steering head.
Locates the key number stamped onto the key connector.
Locates the engine number embossed on the engine.
Locates the fork part number stamped on the fork stub.
Locates the shock absorber article number on the shock absorber.
Describes the clutch lever and its automatic adjustment.
Identifies the hand brake lever for the front brake.
Locates the throttle grip on the handlebar.
Explains the function and states of the kill switch.
Describes the horn button and its operation.
Explains the operation of the light switch for low and high beam.
Describes the operation of the turn signal switch.
Explains the function of the emergency OFF switch.
Describes the electric starter button and its operation.
Details the combination switch for engine mapping and traction control.
Provides an overview of the indicator lamps and their meanings.
Details the procedure for opening the fuel filler cap.
Details the procedure for closing the fuel filler cap.
Explains the function and operation of the cold start button.
Describes the idle speed adjusting screw and its function.
Locates the shift lever and explains gear positions.
Locates the foot brake lever for the rear brake.
Locates the side stand and its parking function.
Locates the steering lock and its function.
Details the procedure for locking the steering.
Details the procedure for unlocking the steering.
Provides an overview of the combination instrument display.
Explains how to activate and test the combination instrument.
Guides on setting the unit of measurement (km/miles).
Details how to adjust various functions of the instrument.
Provides instructions for setting the vehicle's clock.
Explains how to view recorded lap times.
Describes the display mode for showing current vehicle speed.
Describes the display mode for engine operating hours.
Explains how to access and navigate the setup menu.
Guides on changing units like km/h or mph.
Describes the display mode for showing time.
Provides instructions for setting the vehicle's clock.
Describes the display mode for timing lap times.
Explains how to view recorded lap times.
Describes the display mode for showing the total distance traveled.
Describes the display mode for trip master 1.
Describes the display mode for trip master 2.
Guides on manually setting trip master 2.
Describes the display mode for average speed 1.
Describes the display mode for average speed 2.
Describes the display mode for stop watch 1.
Describes the display mode for stop watch 2.
Provides a table summarizing combination instrument functions.
Summarizes conditions for activating instrument menus.
Provides critical advice for the initial use of the motorcycle.
Gives guidelines for the engine running-in phase for longevity.
Offers advice on starting with lithium-ion batteries in cold conditions.
Advises on preparing the vehicle for challenging riding environments.
Provides specific preparation steps for riding on dry sand.
Provides specific preparation steps for riding on wet sand.
Provides specific preparation steps for wet and muddy conditions.
Offers preparation advice for hot weather, slow-speed riding.
Offers preparation advice for cold weather and snow riding.
Lists essential checks before every ride for safe operation.
Provides instructions and safety warnings for starting the motorcycle.
Explains how to activate traction control on specific models.
Details the procedure for starting off from a standstill.
Provides guidance on shifting gears and general riding techniques.
Explains braking techniques and warnings for safe braking.
Details procedures and safety precautions for stopping and parking.
Provides guidelines for safely transporting the motorcycle.
Covers safety precautions and procedures for refueling.
Notes on additional work and country-specific intervals.
Lists mandatory maintenance tasks based on operating hours.
Lists recommended maintenance tasks based on operating hours or time.
Explains how to set suspension based on rider weight for optimal handling.
Explains high-speed and low-speed compression damping.
Details how to adjust the shock absorber's low-speed compression.
Details how to adjust the shock absorber's high-speed compression.
Details how to adjust the shock absorber's rebound damping.
Describes how to measure the rear wheel dimension for sag.
Explains how to check the static sag of the shock absorber.
Explains how to check the riding sag of the shock absorber.
Details how to adjust the shock absorber's spring preload.
Provides instructions for adjusting the riding sag.
Explains how to check the basic fork settings.
Details how to adjust the fork's compression damping.
Details how to adjust the fork's rebound damping.
Details adjusting spring pretension on the fork for specific models.
Explains options for handlebar position adjustment.
Provides instructions for adjusting the handlebar position.
Explains how to safely raise the motorcycle using a lift stand.
Details the procedure for removing the motorcycle from a lift stand.
Provides instructions for bleeding the fork legs.
Details how to clean the dust boots on the fork legs.
Explains the procedure for removing the fork protector.
Details the procedure for installing the fork protector.
Provides instructions for removing the fork legs.
Provides instructions for installing the fork legs.
Details removing the lower triple clamp for specific models.
Details removing the lower triple clamp for specific models.
Details installing the lower triple clamp for specific models.
Details installing the lower triple clamp for specific models.
Explains how to check for play in the steering head bearing.
Details adjusting steering head bearing play for specific models.
Details adjusting steering head bearing play for specific models.
Provides instructions for lubricating the steering head bearing.
Explains the procedure for removing the front fender.
Details the procedure for installing the front fender.
Provides instructions for removing the shock absorber.
Details the procedure for installing the shock absorber.
Explains how to remove the motorcycle seat.
Details how to mount the motorcycle seat.
Explains how to remove the air filter box cover.
Details how to install the air filter box cover.
Provides instructions for removing the air filter.
Details the procedure for installing the air filter.
Provides instructions for cleaning the air filter and box.
Details how to seal the air filter box.
Explains how to secure the air filter box cover.
Provides instructions for removing the main silencer.
Details the procedure for installing the main silencer.
Explains how to change the glass fiber yarn filling in the silencer.
Provides instructions and safety warnings for removing the fuel tank.
Details the procedure and safety for installing the fuel tank.
Explains how to check the chain for dirt accumulation.
Provides instructions and warnings for cleaning the drive chain.
Explains how to check and the importance of correct chain tension.
Details how to adjust the chain tension correctly.
Provides instructions for checking the drive chain and sprockets for wear.
Explains how to check the frame for cracks or deformation.
Explains how to check the swingarm for damage or deformation.
Provides instructions for checking the correct routing of throttle cables.
Explains how to check rubber grips for damage or wear.
Details how to adjust the clutch lever position for comfort.
Explains how to check and correct the hydraulic clutch fluid level.
Provides instructions for changing the hydraulic clutch fluid.
Explains how to remove the engine guard for specific models.
Details how to install the engine guard for specific models.
Explains how to check the free travel of the front brake lever.
Details how to adjust the free travel of the front brake lever.
Explains how to check the front and rear brake discs for wear.
Provides instructions for checking the front brake fluid level.
Details how to add front brake fluid.
Explains how to check the front brake linings for wear.
Provides instructions for changing the front brake linings.
Explains how to check the free travel of the rear brake lever.
Details how to adjust the basic position of the rear brake lever.
Provides instructions for checking the rear brake fluid level.
Details how to add rear brake fluid.
Explains how to check the rear brake linings for wear.
Provides instructions for changing the rear brake linings.
Details the procedure for removing the front wheel.
Provides instructions for installing the front wheel.
Details the procedure for removing the rear wheel.
Provides instructions for installing the rear wheel.
Explains how to check tire condition, tread depth, and age.
Provides instructions for checking and adjusting tire air pressure.
Explains how to check and adjust spoke tension for wheel integrity.
Details the procedure for safely removing the motorcycle battery.
Provides instructions for installing the motorcycle battery.
Gives guidelines for recharging the battery and battery care.
Explains how to change the main fuse for electrical system protection.
Details changing fuses for various vehicle electrical components.
Explains how to remove the headlight mask and headlight assembly.
Provides instructions for installing the headlight mask and headlight.
Details the procedure for changing the headlight bulb.
Explains how to check and verify the headlight aim.
Provides instructions for adjusting the headlight beam range.
Details the procedure for changing a turn signal bulb.
Explains how to replace the combination instrument unit.
Locates the diagnostics connector for vehicle system checks.
Provides an overview of the cooling system's components and function.
Details how to check coolant level and antifreeze protection.
Explains how to check the coolant level in the radiator.
Provides instructions for draining the cooling system.
Details the procedure for refilling the cooling system with coolant.
Explains how to check throttle cable play for smooth operation.
Details how to adjust throttle cable play.
Explains how to change engine response by altering the guide plate.
Details how to change engine mapping via the combination switch.
Provides instructions for adjusting the engine's idle speed.
Explains the procedure for teaching the throttle valve position.
Explains how to check the basic position of the shift lever.
Details how to adjust the basic position of the shift lever.
Provides instructions and safety warnings for changing the fuel screen.
Explains how to check the engine oil level.
Details how to change engine oil, oil filter, and clean oil screens.
Provides instructions for adding engine oil.
Provides guidelines and warnings for cleaning the motorcycle.
Offers advice on winter operation and protection against salt.
Provides steps for storing the motorcycle for extended periods.
Details the steps needed to prepare the vehicle after storage.
Lists technical data for the motorcycle engine.
Provides a list of engine component tightening torques.
Lists capacities for engine oil, coolant, and fuel.
Lists technical data related to the motorcycle chassis.
Lists specifications for the motorcycle's electrical components.
Specifies tire sizes and types for the motorcycle.
Lists technical specifications for the motorcycle's front fork.
Lists technical specifications for the motorcycle's shock absorber.
Provides a list of chassis component tightening torques.
Explains the meaning of yellow and orange warning symbols.
Explains the meaning of green and blue informational symbols.
To Next Page