17 ENGINE 105
– Take off the engine sprocket.
202070-10
– Remove screws 7.
– Remove cable binders 8.
– Take off the clutch slave cylinder with the gasket and hang it to the side.
Info
Do not kink the clutch line.
Do not activate the clutch lever if the clutch slave cylinder has been
removed.
– Take off the clutch push rod.
202072-10
– Pull back the protection cap. Remove nut 9.
– Remove screw bk.
202073-10
– Loosen hose clip bl.
– Pull off the throttle valve body from the rear.
202074-10
– Disconnect connector bm of the gear position sensor, the crankshaft position sensor,
and the alternator.
202075-10
– Pull off the spark plug connector.
– Unplug the connector of the engine coolant temperature sensor bn.
202076-10
– Loosen the spring band clamps bo using the special tool.
Pliers for spring band clamp (60029057100) ( p. 217)
– Pull off the hoses.
To Next Page
Loading...
