To Next Page

To Previous Page

MAINTENANCE WORK ON FRAME AND ENGINE 161

700606-01

– Remove screws .

– Remove cover  with membrane .

– Check the fluid level.

Fluid level below top edge of container 4 mm (0.16 in)

» If the coolant level does not meet specifications:

– Correct the fluid level of the hydraulic clutch.

Hydraulic fluid (15) ( p. 208)

– Position the cover with the membrane. Mount and tighten the screws.

9.66Checking the play in the throttle cable

400192-10

– Move the handlebar to the straight-ahead position. Move the throttle grip backwards

and forwards to ascertain the play in the throttle cable.

Play in throttle cable 3… 5 mm (0.12… 0.2 in)

» If the throttle cable play does not meet specifications:

–

Adjust the play in the throttle cable. x ( p. 162)

Danger

Danger of poisoning Exhaust gases are poisonous and inhaling them may result

in unconsciousness and/or death.

– When running the engine, always make sure there is sufficient ventilation,

and do not start or run the engine in an enclosed space without an effective

exhaust extraction system.

– Start the engine and let it run idle. Move the handlebar to and fro over the entire steer-

ing range.

The idle speed must not change.

Questions and Answers:

Need help?

Do you have a question about the KTM 990 Supermoto R and is the answer not in the manual?

KTM 990 Supermoto R Specifications

General