KTM RC 390 2016 User Manual

3 WORK
7
Finishing work
–
Mount the front rider's seat. ( p. 5)
3.7 Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and safety glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the battery.
– Only charge batteries in well-ventilated rooms.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Preparatory work
– Switch off the ignition by turning the ignition key to the posi-
tion .
– Remove the front rider's seat. ( p. 5)
– Remove the battery cover. ( p. 6)
L02156-10
Main work
–
Pull back negative terminal cover
1
.
–
Disconnect negative cable
2
from the battery.
L02157-11
–
Pull back positive terminal cover
3
.
–
Disconnect positive cable
4
from the battery.
–
Detach rubber band
5
.
– Pull the battery up and out of the battery holder.
Info
Never operate the motorcycle with a discharged battery
or without a battery. In both cases, electrical compo-
nents and safety devices can be damaged. In this case
the vehicle is no longer roadworthy.

KTM RC 390 2016 Specifications

General

Engine Type	Single-cylinder, 4-stroke
Displacement	373.2 cc
Bore x Stroke	89 mm x 60 mm
Transmission	6-speed
Cooling System	Liquid cooled
Rear Suspension	WP monoshock
Rear Brake	230 mm disc, single-piston caliper
ABS	Bosch 9MB two-channel ABS
Seat Height	820 mm
Fuel Tank Capacity	10 liters
Dry Weight	147 kg
Compression Ratio	12.6:1
Starter	Electric starter
Front Tire	110/70 ZR17
Rear Tire	150/60 ZR17
Power	32 kW (44 hp) @ 9, 500 rpm
Torque	35 Nm
Fuel System	Electronic Fuel Injection (EFI)
Front Suspension	WP USD 43 mm
Frame	Steel trellis frame