KTM RC 390 2018 - Mount and Tighten Screws

SETUP 2
3
2.1 Unpacking and setting up the vehicle
A00034-10
– Remove the straps and box.
S01886-01
– Remove the adhesive tape in the upper area of the motorcycle.
A00043-10
– Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking,
leave the other films on the vehicle until you have fin-
ished work on the vehicle.
– Remove the separate enclosure and unpack it. Check the sepa-
rate enclosure for completeness.
– Check the vehicle for transport damage.
S01885-10
Condition
Left and right handlebar stub not mounted.
– Remove protective film on the left and right handlebar
stub.
– Mount left and right handlebar stub on the upper triple
clamp.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Mount and tighten screws
1
.
Guideline
Screw, handle-
bar stub (All
standard mod-
els)
M6 8 Nm (5.9 lbf ft)
Loctite
®
243™
–
Mount and tighten screws
2
.