29PTO
PTO
PTO OPERATION
To avoid personal injury:
A Before operation, be sure to select the correct
PTO lever (mid, mid/rear, rear).
To avoid personal injury:
A Disengage PTO, stop engine, and allow all
rotating components to come to a complete
stop before connecting, disconnecting,
adjusting, or cleaning any PTO driven
equipment.
BPTO Select Lever
The tractor has a 540 rpm rear PTO speed and a 2500
rpm mid-PTO speed.
C Mid-PTO
To use Mid-PTO, shift the PTO select lever to Mid-PTO
position and the PTO clutch lever to "ON" position.
C Mid-Rear PTO
To use mid and rear PTO at the same time, shift the PTO
select lever to mid-rear PTO position and the PTO clutch
lever to "ON" position.
C Rear PTO
To use rear PTO, shift the PTO select lever to rear PTO
position and the PTO clutch lever to "ON" position.
A To avoid shock loads to the PTO, reduce engine
throttle from full to half speed by pushing up on engine
throttle when engaging the PTO, then open the throttle
to the recommended speed.
A To avoid damage of transmission, when PTO select
lever is not smoothly shifted, slightly shift PTO clutch
lever.
A To avoid damage of transmission, do not shift PTO
select lever until the PTO has stopped completely.
C Mid-PTO
The Mid-PTO is available for KUBOTA approved
implements.
C Mid-PTO
C Rear PTO
(1) PTO select lever (A) Rear-PTO position
(B) Mid-Rear-PTO position
(C) Mid-PTO position
(1) Mid-PTO
B2630 B3030/B3000
Engine speed rpm 2753 2600
PTO speed rpm 2500 2500
B2630 B3030/B3000
Engine speed rpm 2768 2592
Shaft 6-spline 6-spline
PTO speed rpm 540 540
To Next Page
Loading...
Need help?
General
