PERIODIC SERVICE68
ENGLISH
EVERY 400 HOURS
BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Remove the split pin, tighten the adjusting nut (tightening
torque 20 N-m, 2.0 kgf-m), then make sure that one of the
nut slots aligns with the split pin hole, tighten the nut
slightly if necessary to align. Replace the split pin.
BChanging Transmission Fluid
To avoid personal injury:
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug. Clean the
transmission strainer. Fill with new KUBOTA SUPER
UDT fluid up to the upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section
and "DAILY CHECK" in "PERIODIC SERVICE"
section.) After running the engine for a few minutes,
stop it and check the oil level again, add oil to
prescribed level. Properly dispose of used oil.
A Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
(1) Adjusting nut
(2) Split pin
Oil capacity 11.6 L
(1) Dipstick
(2) Oil inlet
(A) Oil level is acceptable within this range.
(1) Drain plug
To Next Page
Loading...
Need help?
General
