CABIN
KX080-4, WSM
5-S54
[4] GLASS TRIM TYPE
(When removing)
1. Lift the rubber core by its seam and remove it.
2. Remove the glass to the outside.
(When attaching)
1. From the outside, insert the glass into the glass trim.
2. Insert the rubber core into the groove all the way around the
trim.
3. Start inserting the rubber core at the bottom center. (to prevent
rain from getting in)
RY9212001CAS0090US0
[5] HOW TO REPLACE THE GLASS OF THE RIGHT-SIDE WINDOW
Put something like a piano wire into the outer window frame, pull it along the frame, remove the adhesive agent
and cut it off from the cab frame. Replace the window glass followed by the next procedure.
RY9212032CAS0012US0
How to replace the glass
1. Lift the pin up with a flat-head driver.
Remove the sealant first and lift the pin.
2. Open the window to the point as shown in the figure.
3. Push down to widen up the window frame within elastic
deflection not enough to deform itself permanently and replace
the glass.
And the same way when you install the glass.
4. Put the pin back and apply sealant.
• Use same brand of an adhesive agent and a primer
E.g.)
– Cleaner: TK cleaner made in Daishin Chemistry
– Adhesive agent: Sikaflex-260AP (SikaTack-Go!) or MSI
made Sunrise U90
– Primer: Sika Coating Activator or MSI made Sunrise
Primer 24
RY9212148CAS0023US0
(1) Panel
(2) Glass Trim
(3) Rubber Core
(4) Glass
(a) Inside
(b) Start Here
(1) Pin
(2) Window
(A) Push down to widen up the
window frame
To Next Page
