51THREE-POINT HITCH & DRAWBAR
C Adjusting the high-hitch level
1. Pull the restriction knob and turn the handle upward to
unlock them. Move the high-hitch bracket up and down
to change the hitch height.
2. Align the lock pin with the lock hole. Return the handle
horizontal to lock them. Make sure the restriction knob
has returned to lock position.
BHigh-hitch with Automatic Trailer
Coupling
C COUPLING UP
1. Lift the operating handle upwards as far as it will go
until it blocks.
The coupling pin is raised and the trigger lever is
visible.
2. Slowly reverse the tractor: the drawbar eye on the
trailer must fully penetrate into the hitch assembly until
the trigger lever is released, whereupon the shunt
force produced will cause the immediate insertion of
the coupling pin as well as the automatic retraction of
the security pin.
(1) High-hitch
(2) Restriction knob
(3) Handle
(4) Lock pin
(5) Lock hole
(A) "PULL"
(B) "UN-LOCK"
(C) "LOCK"
(1) Operating handle
(2) Coupling pin
(3) Trigger lever
(4) Security pin
(1) Drawbar eye
(2) Hitch assembly
(3) Operating handle
(4) Coupling pin
(5) Trigger lever
(6) Security pin
To Next Page
