1-3
[2] Emission-Related Installation Instructions
(1) Air Intake System
• Intake system means that layout of all parts from entrance of suction to air-cleaner flange.
• Kubota offers standard Air-cleaner kit. The intake parts should be installed as shown in figure below.
• If you use an OEM intake system for a spec engine, consult Kubota based on the Exhaust Emission Check Sheet
before the application review.
• When the same specification engine is installed on multiple applications, you will have to inform to Kubota prior
to the application review.
Also, the final intake system of each application must be confirmed at the application review and/or the Exhaust
Emission Check Sheet.
• You must install the intake system confirmed at the application review and/or the Exhaust Emission Check Sheet
for mass-production. (Important)
• You should consult Kubota based on the Exhaust Emission Check Sheet whenever you change the intake
system.
Do not change without consultation with Kubota.
WG752, WG972
To Next Page
Loading...
