Z4M-B
VJSM.
02090
DIESEL
ENGINE
[Z]
GENERAL
PRECAUTION
11790F00051
0
During disassembly, carefully arrange removed parts
in
a
clean
area to prevent confusion later. Screws, bolts and nuts should
be replaced in their original position to prevent reassembly
errors.
When special tools are required, use KUBOTA genuine special
tools.
Special
tools
which are not frequently used should be
make according to the drawings provided.
Before disassembling or servicing live wires, make sure to
always disconnect the grounding cable from the battery first.
Remove
oil
and dirt from parts before measuring.
Use only KUBOTA genuine parts for parts replacement to
maintain engine performance and to ensure safety.
Gaskets and O-rings must be replaced during reassembly.
Apply grease to new O-rings or
oil
seals before assembling.
When reassembling external or internal snap rings, position
them
so
that the sharp edge faces against the direction from
which force is applied.
0
Be sure to perform run-in the serviced or reassembled engine.
Do
not attempt to give heavy load at once, or serious damage
may result to the engine.
A
CAUTION
Certain components used in this engine (cylinder head-
gasket, exhaust gasket, etc.) contain asbestos. Handle with
care according to safety regulation.
(1)
Grease
(2)
Force-
(3)
Place the Sharp Edge against the
Direction
of
Force
(A)
External Snap Ring
(B)
internal Snap Ring
01
64051
0030
s-2
To Next Page
Loading...
