t
Tightening toque
t
26.5
to
30.4
N.m
2.7
to
3.1
kgfm
Connecting rod screw
19.5
to 22.4
ft-lbs
2402-B
WSM,
02090
DIESEL
ENGINE
151
PISTON
AND
CONNECTlNG
ROD
11
650F10100
uzl
01
650F10110
01650F10120
Oil Pan and
Oil
Strainer
1.
Unscrewthe oil pan mounting screws
(5),
and remove the oil pan
2.
Unscrew the oil strainer mounting screw
(4),
and remove the oil
(3)-
strainer
(2).
(When reassembling)
Install the oil strainer, using care not
to
damage the O-ring
(1).
Using the hole
(6)
numbered
“2”,
install the oil strainer by
mounting screw.
Apply liquid gasket (Three Bond 1270D or 1270C) to the oil pan
as shown in the figure.
IMPORTANT
Scape
off
the oil adhesive completely. Wipe the’sealing
surface clean using waste cloth soaked with gasoline. Now
apply new adhesive
3
-
5
mm thick all over the contact
surface. Apply the adhesive also on the center
of
the flange
as well as on the inner wall of each bolt hole.
Cut the nozzle of the “fluid sealang” container at its second
notch. Apply “fluid sealant” about
5
mm thick.
Within
20
minutes after the application
of
fluid sealant,
reassemble the components. Wait then for about
30
minutes, and pour
oil
in
the crankcase.
(1)
O-ring
(2)
Oil Strainer
(3)
Oil Pan
(4) Screw
(5)
Oil Pan Mounting Screws
(6)
Hole
11900510192
5-32
To Next Page
Loading...
