Disc mower
42
GMD240-280-310
Putting into service
KN204AGB H
- Lower and lock parking stand (1).
- Lower the tractor three-point linkage to rest the
machine on the ground.
- Uncouple the PTO shaft.
- Place PTO shaft in holder (1).
- Disconnect and store hydraulic hoses in holder (2).
- Remove cord from tractor and store it in its holder on
the machine.
- Detach the top link from the machine end.
- Release the lower links.
- Lower the tractor three-point linkage.
The machine is uncoupled.
When the following equipment is fitted:
Mechanical safety release + Hydraulic pivot +
Lighting and signalling
- Disconnect and store lighting equipment 7-
pin plug in its holder (2).
Always park the machine with the cutter bar
in horizontal position.
To Next Page
Loading...
