KUHL GMD310 - User Manual

Questions and Answers

J
Jenna PerezAug 8, 2025
Why is my KUHL GMD310 Farm Equipment leaving uneven stubble?
- J
  Joseph SparksAug 8, 2025
  Uneven stubble on your KUHL Farm Equipment can occur due to several reasons. Check if the knives are dull, broken, or incorrectly installed—replace them if needed, ensuring the arrow on the knife's upper face points in the disc's rotation direction. Also, verify that the disk speed is sufficient by checking the belt tension and increasing the PTO speed to 540 min-1 if it's too low. Finally, the cutter bar pitch angle may be too high, so reduce it accordingly.
J
Joshua HillAug 12, 2025
What to do if KUHL GMD310 has bad ground contour adaptation?
- B
  Bryan YuAug 12, 2025
  Poor ground contour adaptation with your KUHL Farm Equipment can stem from several factors. Start by adjusting the main frame height relative to the ground. Reduce excessive ground speed. Ensure the hydraulic valve is set in a floating position if it's blocked. Adjust the compensating spring tension if it's incorrect. Finally, inspect the cutter bar pivot bushes for wear or seizure, grease if necessary, and replace them if needed.
O
oholtAug 17, 2025
How to fix stubble that is too long with KUHL GMD310?
- T
  Toni WellsAug 17, 2025
  If the stubble is too long when using your KUHL Farm Equipment, it could be due to an incorrect cutter bar pitch angle. You can modify the pitch angle using the top link. Also, check if the machine is too light, and adjust the compensating spring tension and frame position accordingly.
M
Molly RubioAug 22, 2025
What to do if soil builds up in front of the cutterbar on KUHL Farm Equipment?
- B
  Billy DixonAug 22, 2025
  Soil buildup in front of the cutterbar of your KUHL Farm Equipment can be caused by too much cutterbar down pressure. Adjust the compensating spring tension to resolve this. It can also happen in very wet working conditions, in which case you should adjust the main frame height with regards to the ground and fit raised skid shoes.
R
Rachael TurnerAug 27, 2025
Why does KUHL GMD310 have too frequent safety breakback release?
- K
  Katelyn CampbellAug 27, 2025
  If your KUHL Farm Equipment experiences too frequent safety breakback release, it is likely due to insufficient spring washer compression. Increase the spring washer compression to resolve this issue.
R
rebeccatorresSep 1, 2025
How to improve ground clearance in headland turn position for KUHL GMD310?
- A
  Anne CarrSep 2, 2025
  Insufficient ground clearance in the headland turn position on your KUHL Farm Equipment can occur if the headland turn position valve shuts off too early. Adjust the limiter adjustment screw to correct this.